9
T
Q
BJ
213
4
█
Selecting a preset station
1
Press [PLAY MENU] repeatedly to select
“TUNE MODE”.
2
Press [
R
,
T
] to select “PRESET” and then press
[OK].
3
Press [
2
/
3
] or [
5
/
6
] to select the preset
station.
Improving the sound quality
When “FM” is selected
1
Press [PLAY MENU] repeatedly to select
“FM MODE”.
2
Press [
R
,
T
] to select “MONO” and then press
[OK].
To cancel, select “STEREO”.
“MONO” is also cancelled when you change the
frequency.
To memorise the setting
Continue with step 4 of “Manual presetting”. (
~
8)
Checking the signal status
When “FM” is selected
Press [DISPLAY].
AM allocation setting
For Australia and New Zealand
This system can also receive AM broadcasts allocated in
10 kHz steps.
1
Press [RADIO] to select “AM”.
2
Press and hold [
8
] on the main unit.
After a few seconds, the display panel shows the current
minimum radio frequency. Release the button when the
minimum frequency changes.
• To go back to the initial setting, do the above steps
again.
• Preset frequencies are erased after you change the
setting.
Clock and timers
Setting the clock
This is a 24-hour clock.
1
Press [SETUP] repeatedly to select “CLOCK”.
2
Press [
R
,
T
] to set the time and then press [OK].
To check the time
Press [SETUP] repeatedly to select “CLOCK” and
then press [OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Sleep timer
The sleep timer switches off the system after the set time.
1
Press [SETUP] repeatedly to select “SLEEP”.
2
Press [
R
,
T
] to select the setting (in minutes) and
then press [OK].
To cancel, select “OFF”.
Note:
• The remaining time is shown at every minute except when
other operations are being performed.
“SLEEP 1” will always be shown when only 1 minute
remains.
• The sleep timer always comes first. Be sure not to set an
overlap of timers.
Play timer
You can set the timer to come on at a certain time to wake
you up.
Preparation
Set the clock.
1
Press [SETUP] repeatedly to select “TIMER ADJ”.
2
Press [
R
,
T
] to set the start time and then press
[OK].
3
Repeat step 2 to set the end time.
4
Press [
R
,
T
] to select the music source you want
to play and then press [OK].
To start the timer
1
Press [SETUP] repeatedly to select “TIMER SET”.
2
Press [
R
,
T
] to select “SET” and then press [OK].
“
#
” is shown.
To cancel, select “OFF”.
The system must be switched off for the timer to
operate.
FM - - - -
The FM signal is in monaural.
The system is not tuned in to a station.
FM ST
The FM signal is in stereo.
FM MONO
“MONO” is selected as the “FM MODE”.
HC200.GN.GA TQBJ2134 En_rev1.fm Page 9 Friday, March 23, 2018 3:41 PM
