22
RQT7509
Radio operations
The radio
Note
After changing the “allocation” setting, the frequencies you previously
preset in the memory will be cleared. Preset them again.
7
7
7
7
7
FM frequency step (main unit only)
The step is factory-set to 0.2 MHz, but you can change it to receive
broadcasts allocated to 0.1 MHz steps.
1. Select “FM”.
2. Press and hold [TUNER/AUX].
After a few seconds the display changes to show the current
minimum frequency. Continue to hold the button down. The
minimum frequency changes and the step is changed.
To return to the original step, repeat the above steps.
Manual tuning
or
FM
AM
AUX
TUNER /
AUX
VOLUME
•
Press and hold [
(
] or [
)
] until the frequency starts scrolling to start automatic tuning.
Tuning stops when a station is found.
“ST” is displayed when a stereo FM broadcast is being received.
If noise is excessive in FM
1. Press [PLAY MODE] to display “MONO”.
2. Press [PLAY MODE] again to cancel the mode.
(The mode is also cancelled when you change the frequency)
1
Select “FM” or
“AM”.
2
Select the
frequency of
the desired
station.
3
Adjust the
volume.
Preset tuning
Preset channels to make selection simpler. Up to 15 stations can each be set in the FM and AM bands.
Manual presetting
Tune to the desired station (
A
see above).
PGM
The station occupying a channel is erased if another station is preset
in that channel.
1
Press to
select.
(“PGM” will
appear.)
2
Press while the
station is flashing
to select the
channel.
Automatic presetting
Tune to the frequency where pre-setting is to begin (
A
see above).
PGM
The tuner presets all the stations it can receive into the channels in
ascending order.
When finished, the last station to be set is played.
Selecting channels
1. Press [TUNER/AUX] to select “FM” or “AM”.
2. Press the numbered buttons or [
g
4
/REW] or [
f
3
/FF] to
select the channel.
Press and hold.
(release when “AUTO”
is displayed.)
RQT7509_22_23_new
2/19/04, 4:34 PM
22
