92
Cautions for Use
ª
After Use
1
Take out the Cassette.
(
l
20)
2
Set the [OFF/ON/MODE] Switch to
[OFF].
(
l
20)
3
Detach the Power Source and retract
the Viewfinder.
(
l
18)
4
To protect the Lens, attach the supplied
Lens Cap.
(
l
19)
ª
Tips for using your Palmcorder
When you use your Palmcorder on a rainy or
snowy day or on a beach, make sure that no
water enters the Palmcorder.
≥
Water may cause the Palmcorder or Cassette to
malfunction. (Irreparable damage may occur.)
≥
If sea water splashes onto the Palmcorder, wet a
soft cloth with tap water, wring it well, and use it to
wipe the Palmcorder body carefully. Then, wipe it
again thoroughly with a soft dry cloth.
Keep the Palmcorder away from magnetically
charged equipment (such as a TV, game
equipment, etc.)
≥
If you use the Palmcorder near a TV, images or
sounds may be disturbed due to electromagnetic
wave radiation.
≥
Do not use near a cell phone because doing so
may cause noise to adversely affect the picture
and sound.
≥
Due to strong magnetic fields created by speakers
or large motors, recording on the tape may be
damaged, or images may be distorted.
≥
Electromagnetic wave radiation generated by a
microprocessor may adversely affect the
Palmcorder, causing the disturbance of images
and sounds.
≥
If the Palmcorder is affected by magnetically
charged equipment and does not function
properly, turn off the Palmcorder power and
detach the Battery or AC Adaptor and then
connect the Battery or AC Adaptor again.
Thereafter, turn on the Palmcorder power.
Do not use your Palmcorder near radio
transmitters or high-voltage lines.
≥
If you record pictures near radio transmitters or
high-voltage lines, recorded images or sounds
may be adversely affected.
Do not use this Palmcorder for surveillance
purposes or other business use.
≥
If you use the Palmcorder for a long period of time,
the internal temperature increases and,
consequently, this may cause malfunction.
≥
This Palmcorder is not intended for industrial use.
When you use your Palmcorder on a beach or
similar place, do not let sand or fine dust get
into the Palmcorder.
≥
Sand or dust may damage the Palmcorder or
Cassette. (Care should be taken when inserting
and removing the Cassette.)
Do not spray insecticides or volatile chemicals
onto the Palmcorder.
≥
If the Palmcorder is sprayed with such chemicals,
the Palmcorder body may deform and the surface
finish may peel off.
≥
Do not keep a rubber or plastic product in contact
with the Palmcorder for a long period of time.
When cleaning the Palmcorder, do not use any
solvent, such as benzine, alcohol, thinner, etc.
≥
The Palmcorder body may become damaged and
the surface finish may peel off.
≥
Before cleaning, detach the Battery or pull out the
AC Cable from the AC Jack.
≥
Wipe the Palmcorder with a soft dry cloth. To
remove stubborn stains, wipe with a cloth that is
soaked in a detergent diluted with water and
afterward finish wiping with a dry cloth.
≥
For storing or transporting the Palmcorder, place it
in a bag or case lined with soft pads so as to
prevent the coating on the Palmcorder body from
becoming worn.
After use, be sure to take the Cassette out and
detach the Battery from the Palmcorder or pull
out the AC Cable from the AC Jack.
≥
If the Cassette is left in the Palmcorder, the tape
sags and deteriorates.
≥
If you leave the Battery in the Palmcorder or on the
AC Adaptor, the Battery will no longer be
rechargeable.
ª
About the AC Adaptor
≥
If the temperature of the Battery is extremely high
or extremely low, the [CHARGE] Lamp may
continue flashing, and the Battery may not charge.
After the temperature of the Battery has decreased
or increased sufficiently, charging starts
automatically. If the [CHARGE] Lamp continues to
flash even after the Battery temperature has
decreased or increased sufficiently, the Battery or
AC Adaptor may be faulty. In this case, please
contact your dealer.
≥
If the Battery is warm, charging takes longer than
usual.
≥
If you use the AC Adaptor near a radio, radio
reception may be disturbed. Keep the AC Adaptor
3 feet (1 meter) or more away from radios.
≥
When the AC Adaptor is in use, it may generate
whirring sounds. This is normal.
PV-GS50P.book 92 ページ ２００３年６月１３日 金曜日 午後３時２８分
Summary of Contents for PV-GS50S
Page 111: ...111 Others ...
