[NETWORK] menu
On the menu screen, select [NETWORK] from the main menu, and select an item from the submenu.
Refer to “Navigating through the menu” (
Æ
page 53) for the operation of the menu screen.
[WIRED LAN]
Perform the connection settings to use wired LAN.
1) Press
as
to select [WIRED LAN].
2) Press the <ENTER> button.
f
The
[WIRED DETAILED SETUP]
screen is displayed.
3) Press
asqw
to select an item, and change the setting according to the menu operation instructions.
[DHCP]
[ON]
Set when a DHCP server exists in the network to which the
projector is connected and the IP address is obtained automatically.
[OFF]
Set when a DHCP server does not exist in the network to which the
projector is connected and you need to specify the IP address.
[IP ADDRESS]
Enter the IP address when [DHCP] is set to [OFF].
[SUBNET MASK]
Enter the subnet mask when [DHCP] is set to [OFF].
[DEFAULT GATEWAY]
Enter the default gateway address when [DHCP] is set to [OFF].
[DNS1]
Enter the preferred DNS server address when [DHCP] is set to [OFF].
[DNS2]
Enter the alternate DNS server address when [DHCP] is set to [OFF].
4) After the setting, select [OK] and press the <ENTER> button.
Note
f
For the setting content of each item, consult your network administrator.
f
When using the projector with [DHCP] set to [ON], confirm that the DHCP server is running.
r
Factory default settings
f
Following setting has been made as a factory default.
[DHCP]
[OFF]
[IP ADDRESS]
192.168.10.100
[SUBNET MASK]
255.255.255.0
[DEFAULT GATEWAY]
192.168.10.1
[DNS1] / [DNS2]
(Blank)
[PROJECTOR NAME]
You can change the projector name. Enter the host name if it is required to use a DHCP server.
1) Press
as
to select [PROJECTOR NAME].
2) Press the <ENTER> button.
f
The
[PROJECTOR NAME CHANGE]
screen is displayed.
3) Select characters with the
asqw
buttons and press the <ENTER> button to enter the projector
name.
f
You can enter up to eight characters.
4) After entering the projector name, press
as
to select [OK] and press the <ENTER> button.
[NETWORK CONTROL]
Set up the control method of the network.
1) Press
as
to select [NETWORK CONTROL].
2) Press the <ENTER> button.
f
The
[NETWORK CONTROL]
screen is displayed.
3) Press
as
to select an item and press
qw
to change the setting
.
ENGLISH
-
89
Chapter 4 Settings - [NETWORK] menu
