Setting up
Installation mode
There are four ways to set up the projector. Set the [PROJECTOR SETUP] menu → [PROJECTION METHOD]
(
x
page 87) depending on the installation mode.
Setting on a desk/floor and projecting forward
Setting on a desk/floor and projecting from rear
(Using the translucent screen)
Menu item
Method
Menu item
Method
[PROJECTION METHOD]
[AUTO] or [FRONT/DESK]
[PROJECTION METHOD]
[REAR/DESK]
Mounting on the ceiling and projecting forward
Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Menu item
Method
Menu item
Method
[PROJECTION METHOD]
[AUTO] or [FRONT/CEILING]
[PROJECTION METHOD]
[REAR/CEILING]
Note
f
The projector has a built-in angle sensor. The attitude of the projector is automatically detected by setting the [PROJECTOR SETUP] menu
→ [PROJECTION METHOD] to [AUTO]. For rear projection, set the [PROJECTION METHOD] to [REAR/DESK] or [REAR/CEILING].
r
Angle sensor
The range of installation posture detected by the projector’s built-in angle sensor is as follows.
30°
30°
:
[FRONT/DESK]
[FRONT/CEILING]
Projection direction
32 -
ENGLISH
Chapter 2 Getting Started - Setting up
