74 - ENGLISH
Setting [POWER MANAGEMENT] in Step 3)
Set the operation as following if there is no signal input.
1) Press
as
to select [POWER MANAGEMENT].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[SHUT DOWN]
The countdown timer is displayed after 30 seconds without input signal. The luminous lamp turns off and cools
down when the time set in [TIMER] has elapsed, then the projector enters into standby status.
[OFF]
Power management function is off.
[READY]
The countdown timer is displayed after 30 seconds without input signal. The luminous lamp will turn off and enter
into standby status after cooling down when the time set in [TIMER] has elapsed. The luminous lamp will be turned
on and enter into projection state if any signal is input or any button is pressed during standby mode.
Setting [TIMER]
You can set the time until the luminous lamp turns off with the power management function from 5 minutes to 120
minutes in increments of 5 minutes.
1) Press
as
to select [TIMER].
2) Press
qw
to set the timer.
f
The time will switch each time you press the button.
Setting [STANDBY MODE] in Step 3)
Set the operation mode during standby.
1) Press
as
to select [STANDBY MODE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[NORMAL]
Select this item to use the network function or the serial communication function during standby.
[NETWORK]
Select this item to reduce power consumption during standby, and to operate the projector via the wired LAN or the
serial communication function by using the Wake on LAN function.
[ECO]
Select this item to reduce power consumption during standby.
Note
f
If [STANDBY MODE] is set to [ECO], you cannot use network functions when the projector is standing by. Also, you cannot use some RS-
232C protocol commands.
f
When set to [ECO] or [NETWORK], it may take approx. 10 seconds longer before the projector starts projecting after the power is turned on,
compared with when [NORMAL] is set.
f
If [STANDBY MODE] is set to [ECO] or [NETWORK], it takes less power consumption than it is set to [NORMAL].
f
If [STANDBY MODE] is set to [NETWORK], then even in the standby status, serial communication becomes available within about 75
seconds after 15 seconds have elapsed upon receipt of the Wake on LAN command. In addition, network control becomes available
within about 60 seconds after 30 seconds have elapsed upon receipt of the Wake on LAN command. When a network control command is
received during the period in which network control is available, network control can be continued within about 60 seconds after receipt of
the last command.
f
The setting of [STANDBY MODE] will not return to to the factory default even if the [PROJECTOR SETUP] menu → [INITIALIZE ALL] is
executed (
x
page 78).
[EMULATE]
When controlling the projector on a computer via the <SERIAL IN> terminal, set use of control commands on a
previously purchased Panasonic projector. This allows the control software for an existing Panasonic projector to
be inherited and used.
1) Press
as
to select [EMULATE].
2) Press the <ENTER> button.
f
The
[EMULATE]
screen is displayed.
3) Press
as
to select one item.
[OFF]
Does not use existing control command for the projector.
[D3500]
D3500 series
[D4000]
D4000 series
Chapter 4 Settings - [PROJECTOR SETUP] menu