Chapter 4
Settings — [NETWORK] menu
ENGLISH - 167
Item
Description
[BRIGHTNESS SENSOR]
There is a problem with the luminance sensor. If problems persist even after switching
on the power, consult your dealer.
[PHOSPHOR WHEEL1]
There is a problem with the phosphor wheel 1 or phosphor wheel 1 drive circuit. Consult
your dealer.
[PHOSPHOR WHEEL2]
There is a problem with the phosphor wheel 2 or phosphor wheel 2 drive circuit. Consult
your dealer.
[FILTER UNIT]
The air filter unit is not attached. Check the connection of the air filter unit.
(
x
page 184)
r
[WARNING] items
Item
Description
[INTAKE AIR TEMPERATURE]
The intake temperature is high. The projector may be used in an environment where the
temperature is high, such as near a heating appliance.
[OPTICS MODULE TEMPERATURE]
The temperature around the optics module inside the projector is high. The projector
may be used in an environment where the temperature is high, such as near a heating
appliance.
[EXHAUST AIR TEMPERATURE]
The exhaust air temperature is high. The projector may be used in an environment
where the temperature is high, such as near a heating appliance. Or the air exhaust port
may be blocked.
[LD1 TEMPERATURE]
The temperature of the light source is high. The projector may be used in an
environment where the temperature is high, such as near a heating appliance.
[LD2 TEMPERATURE]
[POWER CIRCUIT TEMPERATURE]
The temperature around the power circuit is high. The air intake port may be blocked.
[FPGA TEMPERATURE]
The temperature inside the projector is high. The air intake port may be blocked.
[BATTERY]
Battery replacement is required. Consult your dealer.
[AIR FILTER]
There is too much dust accumulated in the air filter. Set the <MAIN POWER> switch to
<OFF> (
x
page 63), and clean the air filter. (
x
page 184)
[AC VOLTAGE]
The input supply voltage is low. Use electric wiring that can sufficiently withstand the
power consumption of the projector.
[LOW-TEMPERATURE]
The temperature around the optics module inside the projector is low. Projection cannot
be started until the optics module becomes warm.
[Network status] page
Click [Status]
→
[Network status].
The current network setting status is displayed.
