Panasonic PT-RZ12K, Operating Instructions Manual

Page: 122 / 219

Chapter 4 Settings — [DISPLAY OPTION] menu
122 - ENGLISH
4) Press
qw
to switch the item.
[ENABLE]
Turns off the light source and closes the mechanical shutter when the shutter function is enabled
(shutter: closed).
[DISABLE]
Leaves the mechanical shutter open and turns off only the light source when the shutter function is
enabled (shutter: closed).
Note
f
By closing the mechanical shutter, the malfunction of the DLP chip caused by high power laser ray entering the projection lens surface can
be prevented. To close the mechanical shutter, set [MECHANICAL SHUTTER] to [ENABLE] and then set the shutter function to be enabled
(shutter: closed).
f
When [MECHANICAL SHUTTER] is set to [ENABLE], it will take approximately 0.5 seconds from when the shutter function is enabled
(shutter: closed) to the shutter function is disabled (shutter: opened).
f
The light source may turn on darker to warm up when the shutter function is used when the operating environment temperature is around
0 °C (32 °F) when [MECHANICAL SHUTTER] is set to [DISABLE].
Setting [FADE-IN] or [FADE-OUT]
1) Press
as
to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f
The [SHUTTER SETTING] screen is displayed.
3) Press
as
to select [FADE-IN] or [FADE-OUT].
4) Press
qw
to switch the item.
Item Adjustment
[FADE-IN]
[FADE-OUT]
[OFF] Does not set fade-in or fade-out.
[0.5s] - [10.0s]
Sets the fade-in or fade-out time.
Select an item from [0.5s] - [4.0s], [5.0s], [7.0s], or [10.0s]. [0.5s] -
[4.0s] can be selected in increments of 0.5.
Note
f
Press the <SHUTTER> button on the remote control or the control panel during fade-in or fade-out to cancel the fade operation.
Setting [STARTUP]
1) Press
as
to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f
The [SHUTTER SETTING] screen is displayed.
3) Press
as
to select [STARTUP].
4) Press
qw
to switch the item.
[OPEN]
The projector goes into projection mode with the shutter function disabled (shutter: opened) when the
power is turned on.
[CLOSE]
The projector goes into projection mode with the shutter function enabled (shutter: closed) when the
power is turned on.
Setting [SHUT-OFF]
1) Press
as
to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f
The [SHUTTER SETTING] screen is displayed.
3) Press
as
to select [SHUT-OFF].
4) Press
qw
to switch the item.
[LAST USED]
The projector goes into standby mode with the condition of the mechanical shutter maintained when
the projector is switched off.