Panasonic PT-MZ10K, Operating Instructions Manual

Page: 64 / 248

Chapter 3 Basic Operations — Switching on/off the projector
64 - ENGLISH
Making adjustments and selections
When the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS OPTIMIZER] → [ACTIVE FOCUS] is
set to [OFF], it is recommended to perform the focus adjustment after 30 minutes or more have elapsed with the
focus test pattern displayed.
For details of [ACTIVE FOCUS OPTIMIZER], refer to the [PROJECTOR SETUP] menu
→ [LENS] → [ACTIVE
FOCUS OPTIMIZER] (
x
page 128).
For details of the test pattern, refer to “[TEST PATTERN] menu” (
x
page 150).
7)
1) 9) 6)
8) 10)
2) 3)
2) 3)
4)
5)
1) 6) 8) 9) 10)
4)
1) Press the <FOCUS> button to roughly adjust the focus of the projected image. (
x
page 67)
2) Change the setting of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (
x
page 34)
f
Refer to “Navigating through the menu” (
x
page 76) for the operation of the menu screen.
3) Execute the lens calibration.
f
Execute the lens calibration when using the projector for the first time after attaching the projection lens.
(
x
page 69)
4) Select the input by pressing the input selection button on the remote control or the control panel.
f
The buttons that can be used on the remote control or the control panel are as follows.
Remote control:
<RGB1/2> button, <DIGITAL LINK> button, <DVI-D> button, <SDI> button, <HDMI> button
Control panel:
<INPUT SELECT> button
f
For details of operation for input selection, refer to “Selecting the input signal” (
x
page 66).
5) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (
x
page 42)
6) Press the <SHIFT> button to adjust the position of the projected image.
7)
If the input signal is the analog RGB signal or the DVI-D/HDMI signal, press the <AUTO SETUP>
button.
8) Press the <ZOOM> button to adjust the image size to match the screen.
9) Press the <FOCUS> button again to adjust the focus.
10) Press the <ZOOM> button again to adjust the zoom to match the projected image size to the screen.
Note
f
When the projector is switched on for the first time after purchase, or when initialized by selecting the [PROJECTOR SETUP] menu →
[INITIALIZE] → [FACTORY RESET], the focus adjustment screen is displayed after projection starts, and then the [INITIAL SETTING]
screen is displayed. For details, refer to “When the initial setting screen is displayed” (
x
page 57).
f
If the focus adjustment, periphery focus adjustment, or zoom adjustment is executed while the [PROJECTOR SETUP] menu → [LENS] →
[ACTIVE FOCUS OPTIMIZER] → [ACTIVE FOCUS] is set to [ON], the operation of the temperature detection correction of the active focus
optimizer function will stop.
f
If the lens calibration is executed while the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS OPTIMIZER] → [ACTIVE FOCUS]
is set to [ON], the operation of the temperature detection correction of the active focus optimizer function will stop.