Panasonic PT-MZ10K, Operating Instructions Manual

Page: 129 / 248

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 129
[OPERATION SETTING]
Set the operation method of the projector.
The settings are reflected when “Initial setting (operation setting)” (
x
page 58) in the [INITIAL SETTING]
screen is already set.
If you change the settings while using the projector, the duration until the brightness decreases to half may
shorten or the brightness may decrease.
Setting [OPERATING MODE]
1) Press
as
to select [OPERATION SETTING].
2) Press the <ENTER> button.
f
The [OPERATION SETTING] screen is displayed.
3) Press
as
to select [OPERATING MODE].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[NORMAL] Set this item when the brightness is required. The estimated runtime is approximately 20 000 hours
*1
.
[QUIET]
The brightness will decrease compared to [NORMAL], but select this item when operation with low
noise is prioritized. The estimated runtime is approximately 20 000 hours
*1
.
[USER1]
Set [LIGHT OUTPUT] as desired. [USER2]
[USER3]
*1 Estimated runtime is the time until the brightness decreases to approximately half of the time of delivery when the projector is used with the
[PICTURE] menu → [DYNAMIC CONTRAST] set to [3] and under environment of 0.15 mg/m
3
dust. The value of runtime is just an estimate,
and is not the warranty period.
5) Press
as
to select [APPLY].
6) Press the <ENTER> button.
f
The confirmation screen is displayed.
7) Press
qw
to select [OK], and press the <ENTER> button.
Note
f
The estimated runtime is a time for the luminance to decrease to half.
f
If the runtime exceeds 20 000 hours, replacement of the components inside the projector may be required. Consult your dealer for details.
Setting [LIGHT OUTPUT]
Adjust the brightness of light source.
The [LIGHT OUTPUT] setting is synchronized with the [PROJECTOR SETUP] menu
→ [LIGHT OUTPUT]. The
most recent setting is reflected in both items.
1) Press
as
to select [OPERATION SETTING].
2) Press the <ENTER> button.
f
The
[OPERATION SETTING]
screen is displayed.
3) Press
as
to select [LIGHT OUTPUT].
4) Press
qw
to adjust.
Operation
Adjustment
Range of adjustment
Brightness Runtime (estimate)
Press
w
. The screen becomes brighter. The runtime becomes shorter.
8.0 % - 100.0 %
Press
q
. The screen becomes darker. The runtime becomes longer.
5) Press
as
to select [APPLY].
6) Press the <ENTER> button.
f
The confirmation screen is displayed.