Chapter 3
Basic Operations — Switching on/off the projector
ENGLISH - 55
Switching off the projector
SDI 1/2
VIDEO
ENTER
MENU
LENS
SHUTTER
RGB 1
RGB 2
AUTO
SETUP
DVI-D
HDMI
SDI 1/2
1)
2)
1)
4)
3)
2 )
1) Press the power standby <
v
> button.
f
The
[POWER OFF(STANDBY)]
confirmation screen is displayed.
2) Press
qw
to select [OK], and press the <ENTER> button.
(Or press the power standby <
v
> button again.)
f
Projection of the image will stop, and the power indicator <ON (G)/STANDBY (R)> on the projector body lights in orange. (The fan
keeps running.)
3) Wait until the power indicator <ON (G)/STANDBY (R)> on the projector body lights in red (and the fan
stops) for 170 seconds.
4) Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Note
f
Do not switch on the projector and project images immediately after switching off the projector.
Turning on the power while the lamp is still hot may shorten the lamp life.
f
For about 75 seconds after the projector is switched off and the luminous lamp cooling is started, the lamp indicators will not light up even
if the power is switched on. Even after 75 seconds, the lamp may not light up if the projector is switched on. In such a case, after the power
indicator <ON (G)/STANDBY (R)> lights in red, switch on the projector again.
f
The projector consumes power even when the power standby <
v
> button is pressed and the projector is switched off if the main
power of the projector is on.
When the [PROJECTOR SETUP] menu
→
[STANDBY MODE] is set to [ECO], use of some functions is restricted, but the power
consumption during standby can be conserved.
Direct power off function
Even if the main power <MAIN POWER> switch is turned <OFF> during projection or immediately after turning off the luminous lamp, the
fan runs using internally stored power to cool the luminous lamp. When the projector is mounted on the ceiling or installed in an environment
where the main power <MAIN POWER> switch of the projector cannot be easily turned <OFF>, the power can be turned off directly using the
circuit breaker. It is also safe in case a power outage occurs or the power cord is pulled out immediately after the projector is switched off.
Note
f
If the projector was turned off by turning off the circuit breaker directly during projection last time, then the power indicator <ON (G)/
STANDBY (R)> will light in green a while after the circuit breaker is turned on, and then projection of the image will start.
f
If cooled with the direct power off function, projection may take a longer time than usual to start when the projector is switched on the next
time.
f
Make sure that the fan is not running when packing the projector for transportation or storage.
