[PICTURE] menu
ENGLISH
- 41
Settings
[COLOUR TEMPERATURE]
You can adjust the color temperature if the white
areas of the projected image are bluish or reddish.
Less bluish
Less reddish
Setting range: -6 to +6
z
[SHARPNESS]
With regards to the input signal, adjust video
sharpness using one of [SIMPLE] which adjusts
horizontal direction and vertical direction
simultaneously or [ADVANCED] which adjusts each
individually.
Softer
Sharper
Note
Setting range will vary according to the selected input
z
signal.
[SHARPNESS] can be adjusted using either [SIMPLE] or
z
[ADVANCED]. Both settings cannot be used at the same
time.
Adjusting the [SHARPNESS].
z
(When [SIMPLE] is selected for the
[ADJUSTMENT MODE].)
Press
1)
▲ ▼
buttons to select [SIMPLE].
SHARPNESS
ADJUSTMENT MODE
SHARPNESS
H-SHARPNESS
V-SHARPNESS
SIMPLE
0
PICTURE
POSITION
LANGUAGE
3D SETTINGS
LENS CONTROL
OPTION
Select [SHARPNESS] with the ▲▼
2)
buttons, and adjust with the ▲ ▼
buttons.
Adjusting the [SHARPNESS].
z
(When [ADVANCED] is selected for the
[ADJUSTMENT MODE].)
Press the ◄► buttons to select
1)
[ADVANCED].
SHARPNESS
ADJUSTMENT MODE
SHARPNESS
H-SHARPNESS
V-SHARPNESS
ADVANCED
0
0
PICTURE
POSITION
LANGUAGE
3D SETTINGS
LENS CONTROL
OPTION
Select item with the ▲▼ buttons, and
2)
adjust with the
▲ ▼
buttons.
Pressing the ▲▼ buttons on the screen during
z
adjustment switches to the [H-SHARPNESS] or
[V-SHARPNESS] adjustment screen.
H-SHARPNESS
V-SHARPNESS
0
0
The setting range varies according to the selected
z
picture mode and input signal.
[DYNAMIC IRIS]
You can switch automatic adjustment of the lamp and
the lens iris on/off. This augments the video to create
a video expression with sharp contrast between light
and shade.
Switch settings
Switch settings
[ON]
Automatic adjustment
[OFF]
No adjustment
[WAVEFORM MONITOR]
By using a commercial test disk etc. and setting the
luminance level of the output (brightness) signal from
a connected external device to a value within this
projector’s recommended range, you can perform
adjustment so the display performance of the projector
can be fully leveraged.
Press the <ENTER> button.
1)
The [WAVEFORM MONITOR] menu is displayed.
z
WAVEFORM MONITOR
OFF
FULL SCAN(Y)
FULL SCAN(R)
FULL SCAN(G)
FULL SCAN(B)
SINGLE LINE SCAN(Y)
SINGLE LINE SCAN(R)
SINGLE LINE SCAN(G)
SINGLE LINE SCAN(B)
MONITOR POSITION
AUTO ADJUST
UPPER LEFT
●
Press the ▲▼ buttons to select the
2)
required item.
Select [OFF] to close the waveform monitor.
z
Press the <ENTER> button.
3)
The waveform monitor is displayed.
z
Note
For details, see “Displaying the waveform monitor” in
z
“Remote control operation”. (
page
33
)
