10
3. Fold the template along a "Rear wall" dotted line. Align the center line with center line on the wall and the
top cabinet. Tape the template to the underneath of top cabinet and the wall. (Fig. 2-3)
Taping
Template
Tape
Center Line
Center Line of Wall
Fig. 2-3
3-1 Drill 3 pilot holes at the center point (No.
q
and No.
w
in Fig. 2-1)
If Top Exhaust application is chosen, you will need 4 more pilot holes. (No.
e
in Fig. 2-1)
If Rear Exhaust application is chosen, you will need 4 more pilot holes. (No.
r
in Fig. 2-1)
3-2 Remove the template.
3-3 Drill
two
1
/
2
" holes from the No.
q
pilot holes. Drill a 1
3
/
16
" hole from the No.
w
pilot hole for AC cord.
3-4 If Top Exhaust application is chosen, you will need to cut the Top Exhaust opening. (No.
t
in Fig. 2-1)
If Rear Exhaust application is chosen, you will need to cut the Rear Exhaust opening. (No.
y
in Fig. 2-1)
STEP 3: INSTALLING THE MOUNTING BRACKET
CAUTION:
To support the oven’s weight, bracket must be secured by at least
•
Four wood screws on the wall studs (2 screws on each side) or
•
Two wood screws on the wall studs and 4 toggle bolts through the wall
PREPARATION OF BRACKET ASSEMBLY
Note:
If Rear Exhaust is chosen, the product need a Rear Wall Exhaust cutout opening for the Rear Wall duct
and the Exhaust adaptor must be installed on the bracket (hardware item
y
) with two screws.
(hardware item
t
) (Fig. 2-1).
Check that the damper blade moves smoothly and opens fully as shown. (Fig. 3-1)
Damper Blade
Opens Fully
Exhaust
Damper
Mounting Screws
Fig. 3-1
IP2386_38Q01CP_Eng_04_080105.indd 10
IP2386_38Q01CP_Eng_04_080105.indd 10
2009-1-6 Michael 9:16:49
2009-1-6 Michael 9:16:49
