1. Adjustment of Grounding Plate Unit
A. After installing, make sure that the Grounding Plate Unit, on the
top side of mechanism chassis, is positioned on the front side
of the Cylinder shaft so that the center line of the plate is just
less than 1.0 mm measured from the center of the Cylinder
shaft.
If required, adjust the plate position by loosening Screw (S-1).
Never install the Grounding Plate Unit on the rear side of the
Cylinder shaft.
Incorrect positioning will cause cylinder buzz.
Fig. J2-2
2. After replacing the Cylinder Unit, clear the Total elapsed "Cylinder
rotation" time (in hours) to 0. Refer to "
USAGE SCREEN MODE
" in
SERVICE NOTES.
6.2.5. Capstan Belt, Support Angle, Intermediate Gear B, and Main Cam Gear
Fig. J3-1
29
Summary of Contents for Omnivision PV-V4621
