Panasonic OCU-CR1000VF8A, Operating Instructions And Installation Instructions

Page: 42 / 56

EN - 43 EN - 42
About Alarms
Description of Abnormality Alarm
When the ground fault protector is activated, check insulation of the equipment and circuit, eliminate the cause, and
then supply power again.
Anomaly item
Number
of times
to
automatic
ally
restart
When restarting When stopped
Note
Alarm indication
External
alarm
signal
Communica -
tion signal
Alarm indication
External
alarm
signal
Communica -
tion signal
ALARM
(Red)
LED
Error
code
ALARM
(Red)
LED
Error
code
High pressure anomaly 6 blinking E311 none none lighting E011 output output 1)
Discharge gas temperature anomaly 2 blinking E101 none none lighting E031 output output 2)
Discharge gas temperature sensor anomaly None - - - - lighting E041 output output
Low pressure sensor anomaly None - - - - lighting E05 output output
High pressure sensor anomaly None - - - - lighting E06 output output
Suction gas temperature sensor anomaly None - - - - OFF E07 none none
Oil level anomaly 1 blinking E391 none none lighting E091 output output 3)
Inverter communication anomaly None - - - - lighting
E181
E183
output output
Controller communication anomaly None - - - - OFF E19 none none
Radiator temperature anomaly None - - - - lighting E201 output output
Radiator temperature anomaly None - - - - lighting E221 output output
Ambient temperature sensor anomaly None - - - - lighting E23 output output
Gas cooler fan motor anomaly None - - - - OFF E271 none none 4)
Refrigerant flood back alarm None - - - - OFF E32 none none 5)
Intermediate pressure anomaly 6 blinking E36 none none lighting E46 output output
Unit outlet pressure anomaly 6 blinking E37 none none lighting E47 output output
Intermediate pressure sensor anomaly None - - - - lighting E81 output output
Unit outlet temperature sensor anomaly None - - - - lighting E57 output output
Gas cooler outlet temperature sensor
anomaly
None - - - - lighting E59 output output
Split cycle outlet temperature sensor
anomaly
None - - - - lighting E80 output output
Oil level switch anomaly None - - - - lighting E851 output output
Unit outlet pressure sensor anomaly None - - - - lighting E88 output output
Refrigerant over charge - blinking E84 none none - - - -
Reset method when stopped.
Operate either ground fault interrupter, operation switch, or controller.
1) After stopping for 5 min, then “auto recovery”.
2) Restart when the discharge gas temperature becomes 75°C or below.
3) After stopping for 1 min, then “auto recovery”.
4) After stopping for 60 min, then “auto recovery”
5) Auto recovery when the difference between the evaporating temperature and suction gas temperature is 5K or greater.
01_OCU-CR1000VF8A.indd 42 2019/08/27 10:56:09