Panasonic NV-MX500B, Operating Instructions Manual

Page: 30 / 56

CARD Mode
-30-
CARD Mode
Using a Card
A Card can be used to record still pictures.
≥
Use genuine Card only.
ª
Inserting a Card
Before inserting a Card, be sure to turn off the Movie
Camera.
1
Open the Card Slot Cover (16) .
2
While holding the Memory Card with its cut corner
facing right
1
, insert it into the Card Slot (15) .
3
Close the Card Slot Cover (16) securely.
Removing the Card
Open the Card Slot Cover and press the centre of the Card
and then pull it straight out.
≥
After removing the Card, close the Card Slot Cover.
≥
The Movie Camera may be damaged if the Card is forced
out when the Card is fully inserted.
ª
[ACCESS] Lamp
(14)
While the Movie Camera is making an access to the Card
(reading, recording, playback, erasing or moving of images),
the [ACCESS] Lamp lights up.
≥
While the [ACCESS] Lamp is on, never attempt to open the
Card Slot Cover, to pull out the Card, to turn off the Movie
Camera, or to switch the [TAPE/CARD/CARD MODE]
Selector. Such actions will damage the Card, cause loss of
recorded data and cause the Movie Camera to malfunction.
Recording on a Card
3 kinds of data can be recorded by selecting with the
[TAPE/CARD/CARD MODE] Selector
(13) . When recording
picture, slide the [TAPE/CARD/CARD MODE] Selector until
the [PICTURE] Indication
1 appears (Card Photoshot),
when recording moving picture, slide the
[TAPE/CARD/CARD MODE] Selector until the [MPEG4]
Indication
2
appears (MPEG4 Recording), when recording
voice, slide the [TAPE/CARD/CARD MODE] Selector until
the [VOICE] Indication
3
appears (Voice Recording).
(16)
1
(15)
(14)
CARD MODE
TAPE CARD
(13)
PICTURE
1
MPEG4
2
VOICE
3
≥
If the [TAPE/CARD/CARD MODE] Selector (13) is set to
[CARD] with a Card inserted, the Movie Camera is
automatically turned off when you leave it for about
6 minutes without performing any recording.
≥
When the [TAPE/CARD/CARD MODE] Selector
(13)
is set
to [CARD], you cannot record to the Tape.
ª
Card Photoshot
Still pictures can be recorded on the Memory Card from the
Movie Camera lens as well as from scenes that have already
been recorded on a cassette.
The size of images that are recorded using this Movie
Camera is approximately 3 million pixels, and recording of
images with a size that is larger than a million pixels is called
mega-pixel still-picture recording. Compared to images of
normal recording, images that are created by mega-pixel
still-picture recording can be printed out clear.
Recording from the Movie Camera Lens (CAMERA
Mode)
1
Set the [TAPE/CARD/CARD MODE] Selector (13) to
[CARD].
2
Slide the [TAPE/CARD/CARD MODE] Selector (13) to
[CARD MODE] until the [PICTURE] Indication appears.
≥
Remaining Number of Card Photoshot pictures 1
3
Centre the subject in the focus area
2
on the screen.
≥
In Auto Focus Mode, the Focus Indication 3 is lighted
when the subject is in focus.
Green: getting the focus point
White: getting near to the focus point
4
Press the [PHOTO SHOT] Button
(25)
.
≥
The [ ] Indication lights up in red.
Concerning Low Light Shot
When recording dark scenes, set the [LOW LIGHT SHOT] of
the [CARD SETUP] Sub-Menu to [AUTO]. (When the shutter
speed is 1/25, Low Light Shot is activated, and the [
4
CARD
]
Indication appears.)
≥
When [AUTO] is set for Low Light Shot, the brightness of
the moving picture may suddenly be changed depending
on the scene to be shot.
Recording from a Cassette (VCR Mode)
1
Set the [TAPE/CARD/CARD MODE] Selector
(13)
to
[CARD].
CARD MODE
TAPE CARD
(13)
PICTURE
1
F 7
640
2 3
PHOTO
SHOT
(25)
PICTURE
CARD MODE
TAPE CARD
(13)
B5-B.book 30 ページ ２００２年８月３０日 金曜日 午前１０時４０分