Panasonic NR-F532TT, Servise Manual, Page: 33 / 61

33
12.1.7. PCB (Light Ag)
1. Remove PC duct plate.
(Refer to "12.1.DISASSEMBLY OF PC")
2. Unscrew 2 screws of fixed PCB (Light Ag), then pull the
connector out of PCB (Light Ag) cover. And remove the
connector.
3. Remove PCB (Light Ag) from hooks.
12.1.8. PCB (LED) - LED LAMP PC -
(See the figure below, explanation of left side LED LAMO PC.
Right side is similar to left side.)
1. Remove the hooks of Lamp cover to insert the screw
driver (-) into the next to round mark in the figure.(Lamp
cover is damaged easily. And the inside box of the Lamp
too.)
(Triangle marks cannot see easily. It is a position about
2cm below the upper side, and a position of center. And
3cm upper position from the under side.)
2. Remove PCB (LED) from 2 hooks and disconnect the
connector.
CAUTION DURING INSTALLATION OF PCB (LED)
• nstall PCB (LED) between upper and lower stoppers.
• Because the lamp cover has upper and lower direction, the
position of hooks and the holes need to be matched. Then it
is installed.