18
Appendix
Trays / 1-2 convenient shelf (made of glass)
Once every three months
■
Tray (Upper shelf in the refrigerator)
Unhook the protrusion at the back of the tray and pull it.
Hook
Tray
■
Unhook the protrusion at the front of the 1-2
convenient shelf and pull it.
Front part
Rear part
■
Tray (2nd shelf from the top in the refrigerator)
Lift up the back of the tray and pull it forward.
Once the protrusions of the tray are unhooked from
the rails, tilt the tray and remove it.
Tray
Hook
Rail
■
Rear part of the 1-2 convenient shelf
Remove the front part (refer to the upper figure).
Slightly lift the rear part and pull it.
Fit the rear part of the 1-2
convenient shelf so that the
hole on it is towards you.
Attention
●
The partition shelf is not removable. Do not remove the partition shelf when you clean it.
●
Trays, the 1-2 convenient shelf and the partition shelf are made of glass and heavy.
Please handle them with care so that they do not fall and cause any damage or injury.
For attaching trays, hold them with the protrusion side down and firmly insert.
Case (Prime Fresh/Chilled select room)/Egg case/Small-item case
Once every three months
■
Case (Prime Fresh/Chilled select room)
Pull out the case as far as
possible, lifting up the front
and pull it out at angle with
holding the flap above the
case.
■
Egg case/Small-item case
Pull out the case as far as
possible, and pull out at an
angle while lifting up the front.
Attention
●
The partitions set to both side of the egg case and the small-item case are not removable.
Do not remove the partitions when you clean them.
Door shelf/Bottle shelf
Once every three months
■
Remove
Tap the bottom of the small racks upward
or slide alternately the left and right of the
big racks upward, and raise them slowly.
(Tightly attached)
•Remove the free rack before the bottle rack.
Slide the racks
upward.
■
Re-installing
Set each rack horizontally, with the
mark [>PS<] on the right, and push it
down to its proper position.
•Remove the free rack before the bottle rack.
