Panasonic NR-B32FW2, Service Manual

Page: 44 / 63

44
11.8.5. Install Door A'ssy PC
1. Remove the connector that connect with Door A'ssy PC
a. Remove the screw that is fixation of Cover Cap Door
PCT L.
b. Insert screwdriver (-) into a gap of Cover Cap Door
PCT L, and pry off hooks (2 portions).
Remove Cover Cap Door PCT L.
c. Insert screwdriver (-) into a gap of Cover Harness
PCT L, and pry off hooks (3 portions).
Remove Cover Harness PCT L.
d. Pull out the connector that is connected with Door
A'ssy PC, and remove the connector while pressing
toward upper side.
e. Store the connector in Cover Harness PCT, install
Cover Harness PCT in Door A’ssy PC as before.
2. Install Door A'ssy PC
a. Apply the grease on around Pin Hinge Center.
b. Lift Door A’ssy PC, and insert left bottom of Door A’ssy
PC into Hinge Center L.
3. Install Hinge Top L
a. Through the connector to the hole of Hinge Top L.
CAUTION
• Be careful not to forcibly bend when the connector is
through the hole of Hinge Top L. Because it might be
cause to wire cut and connector damage.
b. Apply the grease on the tongue of Hinge Top L and
insert it into Door A’ssy PC.
c. Three screws that are fixation of Hinge Top L are tem-
porarily screwed.