10. TEST MODE
Number of timers
The “Water Level”
button is pressed
Check
Procedure
Check
Contents
Lamp illumination
condition
Operation condition
●Cycle end buzzer
●When the end buzzer sound
three times, the lamps will flash
on and off the remaining time
display and the power will be
switched off immediately after
operation is finished.
●Timer indicator
0
A
●Auto power off
●Washing operation
●If there is no water in the tub,
the operation still wash.
●If the PCB fault occurred,
an error indication “H05” will
display.
1
B
●Spinning operation
●Lid / SF switch
●The spinning operation,
Check lid & SF switch
operation.
●”Light up” lid switch working.
2
C
●Adjust the water
amount against
amount detection
●Press the “Wash” button to
adjust L0 (initial mode)
L1 (1-rank higher water level).
●Press “Start/Pause” button to
confirm.
3
E
- Set the power switch to "off" as Fig-1.
- Press and hold both the "Water level" and "Wash" buttons with one hand.
- Press the power swith to "on".
- Release your fingers from the buttons and power switch which you pressed same as Fig-2.
- Within three seconds press the "Water level" button to set the desire check procedure.
(Check Contents as press button step by step : A,B,C,E M,G and H)
Fig-1
Fig-2
- 13 -
