EN19
ENGLISH
Problem
Check here
Clean Lamp (r
ed)
The lamp flashes and
lights up even though
no debris has been
sucked up
(not turn off)
●
Is there any debris or dust on the sensor?
→
Maintenance (P. EN17)
The lamp does not flash
nor light up even though
debris was sucked up
The lamp does not go
out easily
●
When the situations are as per the following, the lamp’s lighting up
frequency will increase.
◦
New carpets, long-haired carpets, etc. (detects fluff)
◦
Bedding such as futons and blankets, etc. (detects accumulated
keratin, dandruff, dead mites, or droppings, etc.)
◦
Blankets, etc. (detects fluff)
→
While vacuuming, reduce the debris and fluff, and the lighting up
frequency will decrease.
When it is troublesome, set the sensor’s sensitivity to
“Convenient” (P. EN12)
Operation lamps (blue and r
ed) at same time
The lamp flashes even
though there is very
little debris
●
When the situations are as per the following, the lamp flashes, but there
are no aberrations.
◦
When sand and dirt, etc. are concentratedly sucked in.
→
Clean the dust box (P. EN14)
◦
When the extension wand and nozzle are clogged with debris
→
Remove the debris
◦
When using the telescopic 2-way nozzle
(P. EN13)
The lamp does not flash
even though there is a
lot of debris
●
When there are a lot of pet hair, and cotton debris, it might not flash,
but this is not an aberration.
→
Discard the debris in the dust box (P. EN14)
●
The lamp may not flash correctly during AUTO operation
→
Check that it is in HIGH operation
The lamps light up
●
In order to prevent the motor and battery from overheating, the
safeguard device is working.
→
①
Turn off the operation switch
②
Wait 5 to 30 minutes (the motor and battery cools down, and the
safeguard device is released)
③
Investigate what caused (P. EN6) the safeguard device to work
◦
Continuously operated with a lot of dust accumulated in the dust box
→
Throw away the debris in the dust box, and clean it (P. EN14)
◦
The extension wand and nozzle are clogged up with debris
→
Remove the debris
Noise
The operating sound
makes high and loud
(“Conk, conk” etc.)
noises.
●
Are the net filter and pleat filter clogged up?
→
Clean them (P. EN14)
●
Are the extension wand and nozzle clogged up with debris?
●
Is the nozzle tip blocked?
While it is being used, the
operating sounds fluctuate
●
In AUTO operation, the suction force is interlocked with the clean
sensor so it is automatically adjusted. This is not an aberration.
Smell
The smell of the debris
is coming from the
exhaust
●
Are you leaving the vacuum filled with strongly smelling sucked up debris in it?
→
If you are concerned about this with repeated operating, dispose of
the debris (P. EN14)
→
Clean out each filter (P. EN14, EN17)
Summary of Contents for MC-SB53KH046
Page 2: ...ENGLISH EN 正體 HK BAHASA MELAYU MA TIẾNG VIỆT VI ...
Page 83: ......
