Panasonic KX-TVM50, Programming Manual

Page: 123 / 200

2.5 System Parameters
Programming Guide 123
Message Waiting Lamp Ports
Specifies the port numbers used for Message Waiting Notification Lamp feature. The VPS turns on
the Message Waiting Lamp of the extension using the port specified in this parameter. At least 1 port
must be specified.
Note
• The maximum number of ports depends on the VPS model.
Value Range
1–6 (KX-TVM50), 1–24 (KX-TVM200)
Feature Guide References
2.3.30 Message Waiting Notification—Lamp
Message Waiting Lamp for Every Message
If set to "Yes", the VPS will turn on the Message Waiting Lamp of the extension each time a new
message is recorded in the mailbox. This will occur even if the Message Waiting Lamp was not turned
off from a previous message. This setting is useful when the first attempt is unsuccessful. If set to
"No", the VPS will turn on the Message Waiting Lamp for the first message only. The VPS will not turn
on the lamp for subsequent messages until the subscriber has accessed the VPS to retrieve the
messages stored there.
Value Range
No, Yes
Feature Guide References
2.3.30 Message Waiting Notification—Lamp
Max. Digits for Callback No.
Specifies the maximum number of digits the caller can enter as a callback number. This callback
number will be displayed on beepers if "Beeper Callback No. Entry Mode" is enabled.
Value Range
1–48 digits
Feature Guide References
2.3.29 Message Waiting Notification—Device
Callback No. Entry Interdigit Time-out
Sets the maximum allowable time between each digit on Beeper Callback No. Entry. If the caller does
not enter any digits within the specified time, the VPS will not accept entry of any additional digits.