Sub-menu 1
Sub-menu 2
Settings
Code
Language
Display
<
English
>
#110
Main menu:
“
Baby Monitor
”
Sub-menu 1
Sub-menu 2
Settings
Code
On/Off
–
1:
On
0:
<
Off
>
#268
Sensitivity Level
–
1:
Low
2:
<Middle>
3:
High
#269
Main menu:
“
Calendar
”
Operation
Code
Viewing the calendar and setting the schedule alarm.
#727
*1 If you program these settings using one of the handsets, you do not need to program the
same item using another handset.
*2 This menu is not displayed when scrolling through the display menus. It is only available in
direct command code.
*3 The ringer tone may continue to play for several seconds even if the caller has already hung
up. You may either hear a dial tone or no one on the line when you answer the call.
*4 The preset melodies in this product are used with permission of © 2011 Copyrights Vision
Inc.
*5 If you do not want the unit to ring before the caller information is received, set to
“
Off
”
.
(Caller ID subscribers only)
You can only remove the first ring if the unit rings two times or more by default, which
depends on your service provider/telephone company.
*6 This feature allows the unit to automatically adjust the date and time each time caller
information including date and time is received.
To turn this feature on, select
“
Caller ID
”
. To turn this feature off, select
“
Manual
”
.
(Caller ID subscribers only)
To use this feature, set the date and time first (page 14).
*7 You can set the wallpaper to display with or without date and time by pressing
. The
default setting is with date and time displayed.
*8 You can set the handset display backlight while on charge.
–
“
On
”
: Backlight is on (dimmed).
–
“
Off
”
: Backlight turns off after 10 seconds of charging.
*9 Turn this feature off if you prefer not to hear key tones while you are dialling or pressing any
keys, including confirmation tones and error tones.
*10 If you subscribe to a Caller ID service and want to view the caller’s information after lifting up
the handset to answer a call, turn off this feature.
*11 The recall/flash time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary.
You can access your service provider/telephone company “call waiting” service by having
the recall/flash time set at
“
100 msec.
”
, and then follow your service provider/telephone
company “call waiting” instructions to operate this service. (for Australia)
*12 The default setting will be as follows if you select the following regional codes when
changing the unit’s region setting (page 33):
29
Programming
TG8562_8563AZ(en)_0327_ver021.pd29 29
2012/03/27 14:08:07