5
Select a memory location by pressing
1
to
6
.
a
6
Enter the phone number or area code to
be restricted (8 digits max.).
a
a
M
N
R
To erase a restricted number, press
.
Changing the base unit PIN
(Personal Identification Number)
Important:
R
If you change the PIN, please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, contact
an authorised service centre.
1
(middle soft key)
#132
2
Enter the current 4-digit base unit PIN
(default:
“
0000
”
).
3
Enter the new 4-digit base unit PIN.
a
a
M
N
Changing the unit’s region
setting/Resetting the base unit
Important:
R
When you install the batteries for the first
time, the handset may prompt you to set
the region setting. First press
, then
proceed to step 2.
1
136
2
MbN
: Select the desired country.
a
“
Australia
”
= Australia
“
NewZealand
”
= New Zealand
3
MbN
:
“
Yes
”
a
a
M
N
Note:
R
The following items will be deleted or reset
to their default settings:
– Answering system settings (page 25)
– Time adjustment
– Base unit ringer volume
– Base unit transmission power
– Area code
– Privacy mode
– Base unit PIN
– First ring
– Caller list
– Voice mail messages
– Call restrict
– Category name (Shared phonebook)
– Category ringer tone
R
The following items will be retained:
– Display language
– Date and time
– Phonebook
– Handset name
– Repeater mode
– Recordings, including your greeting
message, caller messages, and
recorded conversations
– Call screening
– Call barred list
R
If you select the desired country in step 2,
the following default settings will be
changed for the selected country’s default
settings:
– Recall/flash time (page 28)
R
After changing the unit’s region setting/
resetting the base unit,
is displayed on
the handset momentarily. This is normal
and the handset can be used once
is
displayed.
Calendar/Schedule
You can program 20 schedule alarms for each
handset using the calendar. A schedule alarm
sounds at the set time for 1 minute. A text
memo can also be displayed for the schedule
alarm.
Important:
R
Set the date and time beforehand
(page 14).
R
If the unit is connected to a PBX system,
date information may not be properly
received. Set the PBX system to receive
the correct date information. Contact your
PBX supplier if necessary.
Adding a new entry
1
(middle soft key)
a
a
33
Programming
TG8562_8563AZ(en)_0327_ver021.pd33 33
2012/03/27 14:08:07
