Preparatio
n
Useful Info
rmation
Answering
System
T
e
lephone System
99
Troubleshooting
General
An incoming message recorded
for a line is not played after
pressing
[MESSAGE]
.
•
Select the line for that message by pressing
[LINE SELECT]
, then press
[MESSAGE]
(p. 74).
Memo messages are not
played after pressing
[MESSAGE]
.
•
You may have pressed
[LINE SELECT]
before
pressing
[MESSAGE]
.
Press
[MESSAGE]
again without pressing
[LINE SELECT]
(p. 74).
Problem
Cause & Remedy
The handset/base unit does not
work.
•
Check the settings (p. 12–17).
•
Check whether the dialing mode setting is
correct (p. 23).
•
Fully charge the battery (p. 16).
•
Clean the charge contacts and charge again
(p. 17).
•
Check battery installation (p. 16).
•
Unplug the base unit’s AC adaptor to reset it.
Plug in, and try again.
•
The handset has not been registered to the
base unit. Register the handset (p. 92, steps 5
and 6).
•
Re-install the battery (p. 16) and fully charge it.
“
Recharge battery
” is
displayed, “
3
” flashes,
or the handset beeps
intermittently.
•
Fully charge the battery (p. 16, 17).
“
Charge for 6 HRS
” and
“
4
” are displayed and the
handset does not work.
•
The battery has been discharged. Fully charge
the battery (p. 16, 17).
You charged the battery fully,
but “
Recharge battery
” is
still displayed and/or “
3
”
continues to flash, or “
Charge
for 6 HRS
” and “
4
” are
displayed.
•
Clean the charge contacts and charge again
(p. 17).
•
The battery may need to be replaced. If you
install a new battery, fully charge it (p. 16, 17).
The CHARGE indicator does
not go out after the battery has
been charged.
•
This is normal.
Problem
Cause & Remedy
TG6500C_Usefulinfo.fm Page 99 Thursday, September 30, 2004 4:58 PM