Problem
Cause/solution
The unit does not work.
R
Make sure the batteries are installed correctly (page 9).
R
Fully charge the batteries (page 11).
R
Check the connections (page 9).
R
Unplug the base unit’s AC adaptor to reset the unit. Reconnect
the adaptor and try again.
R
The handset has not been registered to the base unit. Register
the handset (page 45).
I cannot hear a dial tone.
R
The base unit’s AC adaptor or telephone line cord is not
connected. Check the connections.
R
Disconnect the base unit from the telephone line and connect
the line to a known working telephone. If the working telephone
operates properly, contact our service personnel to have the
unit repaired. If the working telephone does not operate
properly, contact your phone service provider.
The base unit beeps.
R
New messages have been recorded. Listen to the new
messages (page 49).
Error sound is heard when I press
some keys on base unit.
R
Automated call block is being screened. Try again later.
The unit does not emit the
specified number of rings.
R
The number of rings decreases by 1 from the specified number
of rings in below situations:
– the first ring is turned off (
“
No
”
) (page 25).
– automated call block is set to
“
Block
”
(page 27).
– answer by voice command is set to
“
On
”
(page 21).
The unit does not work during a
power failure.
R
You can insert 2 AAA (R03) batteries (not supplied) into the
base unit that will power the unit temporarily in the event of a
power failure (page 11).
R
The base unit display is blank if the saving mode is
“
On
”
(page 12).
Menu list
Problem
Cause/solution
The display is in a language I
cannot read.
R
Change the display language (page 15).
I cannot register a handset to a
base unit.
R
The maximum number of handsets (6) is already registered to
the base unit. Cancel unused handset registrations from the
base unit (page 45).
Battery recharge
Problem
Cause/solution
The handset beeps and/or
flashes.
R
Battery charge is low. Fully charge the batteries (page 11).
I fully charged the batteries, but
–
still flashes,
–
is displayed, or
– the operating time seems to be
shorter.
R
Clean the battery ends (
,
) and the charge contacts with a
dry cloth and charge again.
R
It is time to replace the batteries (page 9).
58
For assistance, please visit http://shop.panasonic.com/support
Useful Information