R
The monitoring unit will answer calls
automatically when the auto intercom feature
is set to
“
On
”
(page 23).
Note:
R
If you receive an outside call when
communicating with the monitored handset,
the interrupt tone sounds.
– To answer the call with the handset, press
M
OFF
N
, then press
M
N
.
– To answer the call with the base unit, press
MZN
3 times.
*1 If
M
MUTE
N
is pressed, press
MZN
2 times.
n
When monitoring from outside:
Answer the call.
If you want to respond from your monitoring
phone, press
#1
using tone dialing.
You can turn off the baby monitor feature by
pressing
#0
.
Note:
R
The unit disconnects the call automatically
after 2 minutes.
Other programming
Changing the handset name
The default handset name is
“
Handset 1
”
to
“
Handset 6
”
. You can customize the name of
each handset (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between handsets.
To display the handset name in standby mode,
turn on the handset name display feature
(page 45).
Handset
1
M
MENU
N#104
2
Enter the desired name (10 characters max.).
a
M
SAVE
N
a
M
OFF
N
Displaying the handset name
You can select whether or not the handset name
is displayed in standby mode. The default setting
is
“
Off
”
.
Handset
1
M
MENU
N#105
2
MbN
: Select the desired setting.
a
M
SAVE
N
a
M
OFF
N
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base
unit.
Important:
R
See page 4 for information on the available
model.
Registering a handset to the base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset is
not registered to the base unit, re-register the
handset.
1
Handset:
M
MENU
N#130
2
Base unit:
Press and hold
M
LOCATOR
N
for about 5
seconds.
R
If all registered handsets start ringing, press
M
LOCATOR
N
again to stop, then repeat this
step.
3
Handset:
Press
M
OK
N
, then wait until a long beep
sounds.
Deregistering a handset
A handset can cancel its own registration to the
base unit, or other handsets registered to the
same base unit. This allows the handset to end its
wireless connection with the system.
Handset / Base unit
1
M
MENU
N#131
R
All handsets registered to the base unit are
displayed.
2
MbN
: Select the handset you want to cancel.
a
M
SELECT
N
3
MbN
:
“
Yes
”
a
M
SELECT
N
4
Proceed with the operation for your unit.
Handset:
M
OFF
N
Base unit:
M
EXIT
N
For assistance, please visit http://shop.panasonic.com/support
45
Programming
