Panasonic KX-TG1105RUS, Service Manual

Page: 61 / 87

24 EEPROM LAYOUT (HANDSET)
24.1. Scope
The purpose of this section is to describe the layout of the EEPROM (IC2) for the KX-TGA110 Handset.
The EEPROM contains hardware, software, and user specific parameters. Some parameters are set during production of the
handset e.g. crystal oscillator adjustment at 0000..01, some are set by the user when configuring the handset e.g. ringer volume
at 0F3E, and some during normal use of the phone.
24.2. Introduction
The handset uses a 32 k bit serial EEPROM (IC2) for storing volatile parameters. All parameters are set up before the handset
the factory. Some of these are vital for the operation of the hardware so a set of default parameters is programmed before the
actual hardware fine-tuning can be initiated. This document lists all default settings with a short description.
This document lists all default parameters with a short description.
In the tables below values in a range that are similar are not repeated; i.e. Address 00 to 01 contains the value 00 simply means
that the value 00 is repeated in all addresses in the range.
Type Name Description
D default The EEPROM location is preset to the Default value by the eeprom default loader.
A adjust The EEPROM location is set during the production test and should not be overwritten. The value is set by the
eeprom default loader only if the location contains 0xFF, i, e. it has never been set.
- EEPROM location which is not set at all.
Country
Setting
x Default - no specific country setting, so revert to default value
24.3. EEPROM contents
24.3.1. General Setup
Address Default Name Country
Setting
Type Description
0000-0001 00 60 EepromOscillator - A Frequency adjustment
0002 0A ModulationDeviation - A Modulation adjustment
0030-0034 00 IPEI (ID for Handset) - A IPEI
0036-003A FF .. FF PARK_1 (ID for Base 1) - - PARK for registration 1
003B-003F FF .. FF PARK_2 (ID for Base 2) - D PARK for registration 2
0040-0044 FF .. FF PARK_3 (ID for Base 3) - D PARK for registration 3
0045-0049 FF .. FF PARK_4 (ID for Base 4) - D PARK for registration 4
004A-004D FF .. FF PLI_1-PLI_4 - D Pli for registration 1-4. If set to FF the
registration is deleted.
0100-0104 - RFPI_1 (Base 1) - - RFPI for registration 1
0105 - SerClass_1 - - Service class for registration 1
0106 - LAL_1 - - Location area level for registration 1
0107 - IPUI_LEN_1 - - IPUI length for registration 1
0108-0114 - IPUI_1 - - IPUI for registration 1
0115 - ZAP_1 - - ZAP for registration 1
0116 - STATUS_1 - - Status for registration 1
0117-126 - UAK_1 - - UAK for registration 1
0130-134 FF .. FF RFPI_2 (Base 2) - D RFPI for registration 2
0135 FF SerClass_2 - D Service class for registration 2
0136 FF LAL_2 - D Location area level for registration 2
0137 FF IPUI_LEN_2 - D IPUI length for registration 2
0138-0144 FF .. FF IPUI_2 - D IPUI for registration 2
0145 FF ZAP_2 - D ZAP for registration 2
0146 FF STATUS_2 - D Status for registration 2
0147-0156 FF .. FF UAK_2 - D UAK for registration 2
0160-0164 FF .. FF RFPI_3 (Base 3) - D RFPI for registration 3
0165 FF SerClass_3 - D Service class for registration 3
0166 FF LAL_3 - D Location area level for registration 3
0167 FF IPUI_LEN_3 - D IPUI length for registration 3
0168-0174 FF .. FF IPUI_3 - D IPUI for registration 3
0175 FF ZAP_3 - D ZAP for registration 3
0176 FF STATUS_3 - D status for registration 3
0177-0186 FF .. FF UAK_3 - D UAK for registration 3
0190-0194 FF .. FF RFPI_4 (Base 4) - D RFPI for registration 4
0195 FF SerClass_4 - D Service class for registration 4
61
KX-TG1105RUS / KX-TG1105R UT / KX-TG1106R US / KX-TG1106R UT / KX-TGA110RUS / KX-TGA110RUT