Panasonic KX-PS8000, Reference Manual

Page: 146 / 155

146
Error message Possible cause Recovery
KX-PS8000 software is not installed
correctly. Status Display does not
exist.
winaspi.dll is not found.
Reinstall the KX-PS8000 software.
SCSI board is not correctly set.
Correctly set the SCSI board in the
computer. (Refer to the instructions
manual of the SCSI board.)
For any other trouble related to SCSI,
refer to the SCSI section of
Troubleshooting
( ☞ P.147) .
Troubleshooting
Click Yes or No on the message window.
Yes: Printer and scanner cannot be used.
Turn off the system (printer / scanner /
computer), then turn it on again.
No: Waits until the printer and/or scanner
responds. Printer and/or scanner are not
responding. SCSI device is not
responded.
SCSI device can not be
used. Because ASPI dll
file is not exist or doesn't
match. Confirm that the SCSI board is correctly
installed in the computer and it is correctly
set. (Refer to the instructions manual of
the SCSI board.)
For any other trouble related to SCSI,
refer to the SCSI section of
Troubleshooting
( ☞ P.147) .
SCSI board is not installed correctly
in the computer and/or it is not set
correctly.
This ASPI manager does
not support this mode of
Windows. You typically
see this error code when
running Windows in Real
Mode SCSI board is not correctly set. Restart Windows in Enhanced mode.
Unavailable LPT port is selected
when using Windows 3.1. There isn't available LPT
Port. Select the other available LPT port by
following the procedure below.
1. Double click the
Main icon.
2. Double click the Control Panel icon.
3. Double click the
Printers
icon.
4. Click Connect... .
5. Click the other port, then click OK.
6. Click Close.