4.4 Programming the Trunk Adaptor
4.4.1 Easy Setup Wizard
In the Easy Setup Wizard, you will set up the mandatory settings required for the Trunk Adaptor.
When you log in to Web Maintenance Console for a Trunk Adaptor that is in its initialised, factory default state,
the Easy Setup Wizard will launch automatically. Log in using the following account name and password.
–
The account name is "INSTALLER".
–
The default account password is "1234".
1.
After Easy Setup Wizard launches, select a language, and then click
Install
.
2.
In
Location and Configuration Setting
:
a.
Select the
Suffix Code of KX-NS1000
from the drop-down list for the PBX you are connecting to.
Note
If
Suffix Code of KX-NS1000
is changed from its default value, a notice about restarting the Trunk
Adaptor is displayed. Click
OK
to restart the Trunk Adaptor. After the Trunk Adaptor restarts, start
Web Maintenance Console again (refer to "Starting Web Maintenance Console" in the Installation
Manual of the KX-NS1000 PBX). When you start the Easy Setup Wizard again, you will start from
step
3
, below.
b.
Select the
Area of KX-NS1000
from the drop-down list for the PBX you are connecting to.
c.
[KX-NS8290 only]
Select a
Network Type
from the drop-down list (
Public
or
Private
).
d.
Specify
SIP Authentication ID Plan
, which is the header digits of the SIP authentication ID for
connecting to a KX-NS1000 SIP trunk.
For example, if "4" (default) is set, numbers 401–430 are registered as the SIP authentication ID for
SIP ports 1–30.
Note
When
Private
is selected for the
Network Type
, this setting is skipped.
3.
In
Adaptor Setting
:
a.
Specify an
Adaptor Name
.
b.
Select a
Time Zone
from the drop-down list.
c.
Click
Next
.
4.
In
LAN Setting
, the IP addresses for the Trunk Adaptor and DNS server can be assigned automatically
through a DHCP server or entered manually.
When using a DHCP server:
a.
Select
Obtain an IP address automatically
.
b.
Select
Obtain DNS server address automatically
.
Notice
The boxes will turn grey and the IP address information will be assigned automatically.
Write down the address information assigned to the Trunk Adaptor for future reference.
c.
Click
Next
.
When not using a DHCP server:
a.
Select
Use the following IP address
.
b.
Enter an IP address
*1
, Subnet Mask
*2
, and Default Gateway
*1
. (The default gateway may not need to
be specified depending on your network configuration.)
c.
Select
Use the following DNS server address
.
Installation Manual
39
4.4.1 Easy Setup Wizard
