Panasonic KX-NCP500, Installation Manual

Page: 108 / 142

3.13 Starting the PBX
3.13.1 Starting the PBX
WARNING
Make sure that the AC outlet is properly grounded, then securely connect the 3-pin AC plug
including the grounded pin.
CAUTION
•
Use only the AC power cord included with the PBX.
•
Before touching the System Initialize Switch, discharge static electricity by touching ground or wearing
a grounding strap.
•
Once you have started the PBX and if you unplug the PBX, do not perform the following procedures
to start the PBX again. Otherwise, your programmed data is cleared. To restart the PBX, refer to
"5.1.4 Using the Reset Button".
•
The power supply cord is used as the main disconnect device. Ensure that the AC outlet is located
near the equipment and is easily accessible.
Notice
The SD Memory Card must be inserted in the SD Memory Card slot of the IPCMPR card before startup.
Note
The PBX will continue to be powered even if the power switch is turned "OFF".
System Initialization Procedure
1.
Slide the System Initialize Switch to the "SYSTEM INITIALIZE" position.
Reset Button
RUN Indicator
System Initialize Switch
108 Installation Manual Document Version 2011-10
3.13.1 Starting the PBX