8. Programmable Features
64
To transfer a recorded incoming message to
another telephone (page 58), activate this
feature and program the transfer telephone
number.
1.
Press
{
MENU
}
.
2.
Press
{#}
, then
{
6
}{
0
}
.
3.
Press
{A}
or
{B}
repeatedly to select “
ON
”.
4.
Press
{
SET
}
.
5.
Enter the transfer telephone number.
6.
Press
{
SET
}
.
7.
Press
{
MENU
}
.
Code #61: Checking, recording or erasing the
transfer greeting message
TRNS-GREETING
CHECK
[
±
]
See page 58 for details.
Code #67: Setting the incoming message
monitor
ICM MONITOR
MODE=ON
[
±
]
To hear an incoming message (ICM) from the
speaker when the answering machine is
recording the message.
“
ON
” (default): You can monitor the incoming
message.
“
OFF
”: Deactivates this feature.
Code #70: Calling your pager
PAGER CALL
MODE=OFF
[
±
]
See page 59 for details.
Code #76: Setting the connecting tone
CONNECTING TONE
MODE=ON
[
±
]
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones;
fax tone, ring back tone and busy tone. You can
use those tones to confirm the status of the other
party’s machine.
L
If the ring back tone continues, the other
party’s machine may not be a facsimile or
may have run out of paper. Check with the
other party.
L
The connecting tone volume cannot be
adjusted.
“
ON
” (default): You will hear connecting tones.
“
OFF
”: Deactivates this feature.
Code #77: Changing the receiving mode in
the AUTO ANSWER setting
AUTO ANSWER
MODE=TAM/FAX [
±
]
“
TAM/FAX
” (default): Telephone Answering
Machine/Fax mode (page 45)
“
FAX ONLY
”: Fax only mode (page 46)
Code #80: Resetting advanced features to
their default settings
SET DEFAULT
RESET=NO
[
±
]
To reset the advanced features:
1.
Press
{
MENU
}
.
2.
Press
{#}
, then
{
8
}{
0
}
.
3.
Press
{A}
or
{B}
repeatedly to select “
YES
”.
4.
Press
{
SET
}
.
5.
Press
{
SET
}
again.
6.
Press
{
MENU
}
.
8.4 Direct commands for
programming features
You can also select the desired setting by directly
entering the program code (# and a 2-digit
number) and direct command.
For more details on the features, see page 60 to
page 64.
1
Press
{
MENU
}
.
2
Press
{#}
and the 2-digit code number.
3
Press the desired direct command, using the
dial keypad, to display the desired setting.
L
This step may be slightly different
depending on the feature.
4
Press
{
SET
}
.
5
To exit programming, press
{
MENU
}
.
8.4.1 Program code and direct
command button
{#}{
0
}{
0
}
Quick Setup
–
{
1
}
: “
TAM/FAX
” (default)
–
{
2
}
: “
DIST. RING
”
–
{
3
}
: “
TEL ONLY
”
–
{
4
}
: “
FAX ONLY
”
L
Press
{
SET
}
2 times before pressing the
direct command button.
FPG376.book Page 64 Wednesday, July 30, 2003 6:28 PM
