Panasonic KX-FP145C, Operating Instructions Manual

Page: 47 / 82

7. Answering Machine
45
unit will ask you to leave a marker message
(page 45).
7.4.3 Other remote operations
Erasing a specific message
Press
{*}{
4
}
while listening to the message you
want to erase.
L
A long beep and 3 short beeps will sound.
The unit will then play back the next
message.
Erasing all the messages
Press
{*}{
5
}
to erase all the messages.
L
A long beep and 3 short beeps will sound.
Monitoring the room
Press
{
6
}
to monitor the sound for about 30
seconds in the room where the unit is installed.
L
After 30 seconds, a beep will sound. To
continue monitoring, press
{
6
}
again within
10 seconds.
Recording a marker message
After playing back the messages, you can leave
an additional message.
1. Wait for 3 beeps indicating the end of the
remote operation.
2. 1 beep will sound.
3. Wait about 10 seconds.
4. Listen for the voice guide or 1 beep to sound.
5. Leave a message.
Re-recording your greeting message
You can change the TAM/FAX greeting
message.
1. Press
{
7
}
to start recording.
L
A long beep will sound.
2. Speak clearly for up to 16 seconds.
L
If you pause for over 2 seconds, 6 beeps
will sound and recording will stop. Repeat
from step 1 within 10 seconds.
3. When finished recording, press
{
9
}
.
L
The new greeting message will be played.
Skipping the greeting message
Press
{
0
}
during the greeting message
playback.
L
The unit will skip the rest of the greeting
message.
Turning message transfer ON or OFF
You must program a transfer telephone number
beforehand (feature #60, page 54).
Press
{
8
}{
1
}
to turn ON the message transfer.
Press
{
8
}{
2
}
to turn OFF the message transfer.
L
If a transfer telephone number is not
programmed, you cannot turn this feature on.
6 beeps will sound.
Turning pager call ON or OFF
You must program a pager number beforehand
(feature #70, page 54).
Press
{
8
}{
3
}
to turn ON the pager call.
Press
{
8
}{
4
}
to turn OFF the pager call.
L
If a pager number is not programmed, you
cannot turn this feature on. 6 beeps will
sound.
Changing the receive mode
Press
{
8
}{
0
}
to change the receive mode from
TAM/FAX to TEL.
L
You cannot return to TAM/FAX mode in the
same call. To return to TAM/FAX mode, see
the following.
Setting to TAM/FAX mode from TEL mode
1. Call your unit and wait for 10 rings.
L
The answering machine will temporarily
answer the call.
2. Enter the remote operation ID during the
greeting message.
L
A long beep will sound, and your unit will
switch to TAM/FAX mode.
3. Hang up the handset.
FP145C_en.book Page 45 Thursday, March 11, 2004 11:00 AM