HLC
After you enabled HLC function, the device can
lower the brightness of the brightest section
according to the HLC control level. It can reduce
the area of the halo and lower the brightness of
the whole video.
The value ranges from 1 to 100. The default
value is 50 when HLC is on.
HLC is enabled only when anti-flicker is outdoor
and exposure mode is auto.
OFF
It is to disable the BLC function. Please note this
function is disabled by default.
Mirror
It is to switch video left and right limit.
This function is disabled by default.
Flip
It is to switch video up and bottom limit. This function is
disabled by default.
DNR
It is to switch digital noise reduction on and off.
DNR Level
It is to set digital noise reduction level. The value ranges from 1
to 100. The default value is 50.
Cancel
It is to cancel the operation in current interface and restore
previously saved operation.
Default
It is to set device default setup.
Profile Management
4.2.3
The profile management interface is shown as in Figure 4-12.
Figure 4-8
36
Summary of Contents for K-EF134L02AE
Page 32: ...Figure 4 4 Figure 4 5 28 ...
Page 33: ...Figure 4 6 Figure 4 7 29 ...
