![background image](http://html.mh-extra.com/html/panasonic/homehawk-window/homehawk-window_information-and-troubleshooting-manual_277505016.webp)
16
T
roubleshooting (Initial setup by selecting “Bluetooth”)
Problem
LED color
Cause
Solution
When initial setup
is performed using
Bluetooth‚ the
following screen is
displayed and the
setup cannot be
completed.
The camera’s
LED indicator is
blinking in red.
If the LED indicator is blinking in red‚ unplug the camera and then plug
it in again‚ check the following causes and solutions‚ and then try again
from the beginning.
The wireless network
password may be
incorrect.
• Enter the correct password for the wireless
network.
•
Unplug the camera and then plug it in again‚
and then try again from the beginning.
The DHCP function of
your wireless router
may be disabled.
•
Confi rm that the wireless router’s DHCP settings
are enabled. Refer to your wireless router’s
manual.
•
Unplug the camera and then plug it in again‚
and then try again from the beginning.
The address fi lter
function of your
wireless router may
be enabled.
• Register the MAC address (page 4) of the
camera to the address fi lter setting of the
wireless router. Refer to your wireless router's
manual.
The camera’s LED
indicator is lit in
blue.
A network clash has
occurred because
you have 2 wireless
routers at home that
are using the same
channel or channels
of a close frequency.
• Unplug all the wireless routers and plug them
in again.
If the situation still does not improve‚ refer to
your wireless router’s manual for information
on how to change the router channel of your
wireless network.