![background image](http://html.mh-extra.com/html/panasonic/homehawk-window/homehawk-window_information-and-troubleshooting-manual_277505006.webp)
6
LED indicator
Status
Off
• No power
• LED indicator is turned off *
1
Yellow
lit
Not registered to your wireless router (usually for initial setup) or signal level is good *
2
blinking slowly
Initial setup is being performed using WPS on your router
Green
lit
• Registration successfully completed
*
3
• Signal level is strong
*
2
blinking slowly
Registration mode or updating
blinking quickly
Camera is searching for your wireless router
Blue
lit
Connected to the wireless router and camera is on
Red
lit
• Registration failed *
3
• Accessing microSD card (when using 24/7 recording)
• Signal level is weak *
2
blinking
• Camera is out of range of your wireless router *
2
• Wireless LAN connection failed
• Device error (fan error)*
4
blinking slowly
• Streaming data
*
1
or detecting motion *
1
• Accessing microSD card (when not using 24/7 recording)
*1
You can configure the camera so that its LED indicator does not light during normal operation from the
camera settings of the app. For more information‚ access the User’s Guide (
page 3).
*2
The signal level (strong‚ good‚ weak‚ out of range) is shown for 3 seconds after pressing
SETUP
button.
*3 Lights for 3 seconds after registration is successfully completed or failed.
*4 Unplug the camera and then plug it in again. If the message is still displayed, contact an authorized service
center.