Panasonic HG-S Series, User Manual, Page: 71 / 200

BASIC OPERATION
© Panasonic Industrial Devices SUNX Co., Ltd. 2019 4-27
4-3-2 Statuses and Measures
The statuses judged by the self-monitoring function are classified into the following four categories.
When the status is "notification", "caution", or "fault", you must check the installation state or
maintain or replace the product.
Status Description Remarks
Normal Normal state The device is operating normally.
Notification Unstable detection state Review the settings.
Caution State in which the device must be replaced The device has almost reached its service life.
Fault State in which the device is uncontrollable The device is short-circuited or broken.
If “notification”, “caution”, or “fault” status is displayed, take measures as shown in the following table.
Response parameter Measures Error code(Note1)
Measurement
alarm(Note1)
Notifi -
cation
Sensor head unconnected Status check E200 –
Connected unit count check error Status check
E160(For master
units only)
–
NPN / PNP output types mixture error Status check
E100(For master
units only)
–
Calculated unlit count error Status check
E110(For master
units only)
–
Copying was executed but it failed be-
cause the slave unit was abnormal
Status check
E170(For master
units only)
–
The thrust on the sensor head
stroke is above the specified range.
Status check E210 –
Pressure check Status check – Alarm
Catch check Status check – Alarm
Fault
Controller memory function damaged
Controller
replacement
E600 / E610 / E620 –
Sensor head memory function dam-
aged
Sensor head re-
placement
E630 –
Output section short-circuit error
Status check / Re-
placement
E700 –
Detection circuit damaged
Sensor head re-
placement
E240 –
System error
Controller
replacement
E900 / E910 / E911 /
E912 / E920
–
Note1: Error codes and measurement alarms are displayed on HG-SC □ controllers.
Note2: This product does not have “Caution” information.
<Reference>
● For details on how to read each status, refer to the user's manual of the communication unit
SC-
HG1
series
(
except the
SC-HG1-USB
)
that you use.