23
VQT3K35
Inserting/removing an SD card
Caution:
Check that the access lamp has gone off.
1
Open the LCD monitor.
2
Open the SD card/terminal
cover and insert (remove) the
SD card into (from) the card
slot.
≥
Face the label side
B
in the direction
shown in the illustration and press it
straight in as far as it will go.
≥
Press the center of the SD card and then
pull it straight out.
3
Securely close the SD card/
terminal cover.
≥
Securely close it until it clicks.
≥
Do not touch the terminals on the back of
the SD card.
≥
Do not apply strong shocks, bend, or drop
the SD card.
≥
Electrical noise, static electricity or the
failure of this unit or the SD card may
damage or erase the data stored on the
SD card.
≥
When the card access lamp is lit, do not:
j
Remove the SD card
j
Turn the unit off
j
Insert and remove the USB cable
j
Expose the unit to vibrations or shock
Performing the above while the lamp is on
may result in damage to data/SD card or
this unit.
≥
Do not expose the terminals of the SD
card to water, dirt or dust.
≥
Do not place SD cards in the following
areas:
j
In direct sunlight
j
In very dusty or humid areas
j
Near a heater
j
Locations susceptible to significant
difference in temperature (condensation
can occur.)
j
Where static electricity or
electromagnetic waves occur
≥
To protect SD cards, return them to their
cases when you are not using them.
≥
About disposing of or giving away the SD
card. (
l
146)
When using an SD card not from Panasonic, or one previously used on other equipment,
for the first time on this unit, format the SD card. (
l
45) When the SD card is formatted, all
of the recorded data is deleted. Once the data is deleted, it cannot be restored.
Access lamp [ACCESS]
A
≥
When this unit is accessing the SD
card, the access lamp lights up.
HDCSD800P-VQT3K35_mst.book 23 ページ ２０１０年１２月２０日 月曜日 午前９時４分
