34
Note:
The destination to save “AWC” can be specified for each scene file. (
•
☞
Page 33)
If “AWC NG” appears and the indicator stays on or if the indicator lights when a scene file is
•
changed, retry the steps 1 and 2.
When “MANU” is selected, follow the steps below to adjust the white balance.
Step 1
Select “MANU”, and then press the [SEL] but-
ton.
The “WHITE BAL” screen appears.
A
Step 2
Move the cursor to “R-GAIN” or “B-GAIN” and
use the [
e
] or [
f
] button to select the white
balance.
** WHITE BAL **
R-GAIN ....
|
....128
−
+
B-GAIN ....
|
....128
−
+
RET END
“WHITE BAL” screen
11. Synchronization setting [SYNC]
The synchronization state is displayed. The horizontal phase for the external synchronization can
also be adjusted. The internal synchronization is indicated as “INT”, and the external synchroniza-
tion is indicated as “EXT2” or “EXT1” as the external synchronization mode.
EXT2 (default):
Select this setting when connecting this unit mutually.
EXT1:
Select this setting when providing the synchronization signal from another device to this unit.
Adjustment of the horizontal phase in the external synchronization mode
Top screen of SETUP menu
“SYNC” screen
<When connecting this unit mutually>
** SET UP ** P2
SCENE FILE *FILE1
WHITE BAL *MANU
SYNC *EXT2
END
** SYNC **
H PHASE ....
|
.... 0
−
+
RET END
Step 1
Provide the synchronizing output signal from
the RGB/YPbPr output connector Pin No. 6
(G/L OUT) of the master CCU to the RGB/
YPbPr output connector Pin No. 7 (G/L IN) of
the slave CCU.
Select the same video format setting for both
CCUs. (
☞
Pages 13 and 14)
Step 2
Move the cursor to “SYNC” on the top screen
of the SETUP menu.