9
8. Insert fan body and slide into adaptor assy with some
TM
strength, untill the flange overlaps the Flex-Z Fast
TM
bracket. Secure the fan body to Flex-Z Fast bracket
by using 2 self-drilling screws, plug connector to
receptacle and secure the fan body to adaptor by
using machine screw (M4X6). (Fig.6)
Mount junction box cover carefully so that
lead wires are not pinched.
Secure machine screw (M4X6) to
TM
hole and not touch the Flex-Z Fast bracket.
Please fix the screw carefully to avoid screw
slip teeth.
the suitable
7. Refer to wiring diagram on page 5.
Follow all the local electrical safety codes as well
as the National Electrical Code (NEC).
Using UL approved wire nuts, connect house
power wires to ventilating fan wires. (Fig.5)
Fig.5
FV-05-11VKSL1
FV-05-11VKL1
FV-11-15VKL1
Fig.6
10. Remove the tapes from louver and springs before
installation. Remove screw (M4X8) and light cover.
(Fig.8)
Conduit
Wire nut
Live to black
(Fan)
Live to black
(Light)
Netural to white
Netural to
white
Junction
box
Two red wires (Connect
to a general manual
wall switch)
Earth ground to green
INSTALLATION (NEW CONSTRUCTION) CONTINUED
CAUTION
CAUTION
Machine
screw
(M4X6)
2 Self-drilling
screws
Joist
Plug connector
Receptacle
9. Finish ceiling work. Ceiling hole should be aligned
with the inside edge of the flange. (Fig.7)
Fig.7
10 1/2
(270)
10 1/2
(270)
Ceiling
Unit: inches (mm)
After finishing the ceiling job, fill gap between flange
and ceillng with caulk or other sealant to prevent air
leakage
Fig.8
Fig.10
Secure
screw
(M4X8)
Fig.9
LED lamp
Remove screw
(M4X8)
Light cover
Light cover
Tapes
IMPORTANT:
Replace the sensor cover before the installation
(only for plug-in Motion sensor module FV-MSVK1).
As shown below:
11. Install the LED lamps. (Fig.9)
12. Install light cover. (Fig.10)
13. Insert the grille mounting spring on the wiring side
into the slot and insert the plug connector into the
housing of the lighting unit. (Fig.11 of page 10)
Keep on pressing the clasps when removing the ornamental cover.
Ornamental
cover
Sensor
cover
Insert the sensor cover (attachment for FV-MSVK1) into slot.
Gloves
