44
Q12
The presence detection indicator turns
on even when no one is moving.
A
Ɣ
If there are changes in temperature, such as
when an oscillating heater is used, the
sensor may detect movement even if there
is no one moving.
Q13
To turn off the presence sensor
detection. (Change the sensitivity of
the sensor)
A
Ɣ
The sensitivity of the presence sensor can be
changed. (The initial setting is [Standard].)
Stop operation, then press and hold
and
simultaneously.
(“Humidification” indicator is lit in order.)
Release the buttons when the sensitivity
you want is obtained.
(“Humidification” indicator)
Standard: To set ideal sensitivity
OFF: To stop detection
High: To set high sensitivity
Q14
Using “Absence cleaning” mode when
people are in the room.
A
Turn off the presence sensor detection. (Q13)
Set the product to “Absence cleaning” mode.
The product operates in [Preparation mode]
for approximately 5 minutes, and [Cleaning
mode] for approximately 60 minutes. After
[Cleaning mode] is complete, the product
switches operation to clean air mode
(automatic air volume and airflow).
If dirt is detected, the product operates in
[Cleaning mode] again.
To end, press
to cancel
“Absence cleaning” mode.
The product returns to the operating mode
before “Absence cleaning” mode.
Q15
There is dust in the room even after
running “Absence cleaning” mode.
A
Ɣ
“Absence cleaning” cleans dirt in the air, and
cannot remove dust on the floor.
Q16
Turning off ECONAVI operation.
A
Ɣ
ECONAVI operation can be turned off.
Ɣ
Press
and
simultaneously and hold for approximately
3 seconds while the product is operating
with the “Air volume” setting to [Auto].
(The ECONAVI indicator is turned off.)
Ɣ
To restart ECONAVI operation, while the
product is operating with the “Air volume”
setting to [Auto], press the buttons and
hold for 3 seconds again.
(The ECONAVI indicator is lit.)
Q17
Turning off “nanoe
TM
”.
A
Ɣ
nanoe™ operation can be turned off.
Ɣ
During operation, press
and
simultaneously and hold for
3 seconds. (The nanoe™ indicator is
turned off.)
Ɣ
To restart nanoe™ operation, press the
buttons and hold for 3 seconds again.
(The nanoe™ indicator is lit.)
FAQs
VXL95M_EN-ARA.indd 44
10/15/2015 5:47:48 PM
