Panasonic EYFPA1C, Operating Instructions Manual

Page: 31 / 44

EN EN
- 1 -
EN EN
1
Attach the socket to the tool.
2
Insert the pin. (Taking care to align the pin
holes on the socket and tool.)
3
Attach the rubber ring by sliding it into
place over the groove.
[Fig.2]
NOTE:
Be sure to attach the rubber ring to pre-
vent the pin from falling out.
Removing Socket (Pin type)
1
Remove the rubber ring.
2
Remove the pin.
3
Remove the socket from the tool.
[Fig.3]
NOTE:
Keep the temperature of the tool above
the freezing point (0°C/°F) when
attaching sockets to or removing them
from the square drive on the tool. Do
not use excessive force when attaching
or removing sockets.
Attaching or Removing Bat­
tery Pack
1. To connect the battery pack:
Line up the alignment marks and attach
the battery pack.
Slide the battery pack until it locks into
position.
[Fig.4]
. To remove the battery pack:
Push down the button and slide the battery
pack forward.
[Fig.5]
Attaching the tool hanger
1. Remove the pin and the clip from the tool
hanger.
[Fig.6]
. Align the holes on the tool hanger with the
holes on the tool body.
[Fig.7]
. Insert the pin into the holes on the tool
hanger and the tool body.
Attach the clip on the tool hanger's holes.
[Fig.8]
IV
.
OPERATION
WARNING
Do not inhale any smoke emitted from the
tool or battery pack as it may be harmful.
Comparison chart for EYFA1 / EYFA0
remote control
EYFA31 EYFA30
D button (P) Torque level button (V)
C button (Q) Format button (W)
B button (R) Interval set button (X)
A button (S) Torque set button (Y)
This operating instruction is written with
the contents of EYFA1 model.
In the case of use with EYFA0, refer to
the above chart and replace EYFA0 with
EYFA1.
Before Using the Remote
Control (Available as an
optional accessory)
[Fig.9]
Insert the battery
1. Pull out the battery holder.
1
Push in on the fastener as indicated by the
arrow.
2
Pull out the holder.
. Insert the battery and push the holder
back in.
NOTE:
If the tool does not respond to the wire-
less remote control even when the
remote control is operated close to
the tool, the battery (CR0) is dead.
Replace it with a fresh battery.
The included battery is provided for
sample use and may not last as long as
commercially available batteries.
•
•