- -
EN
EN
EN
EN
Wireless remote control range
[Fig.10]
The remote control should be operated within
approximately 0 cm and approximately 60°
vertically and horizontally of the perpendicular
relative to the infrared receiver on the tool.
• Under the following circumstances, you may
not be able to operate the tool, even within
this range.
- If there is an object between the remote
control’s transmitter and the tool’s receiver.
- Use outdoors or in other environments
where the remote control receiver is
exposed to a strong light source, or when
the remote control transmitter or receiver is
dirty may cause the tool to fail to respond,
even when the remote control is used within
the operating range.
[Main Unit]
CAUTION:
If a tool holder is used with the
Panasonic EYF series assembly tools,
make sure the tool’s trigger switch
doesn’t hit the tool holder. It may run
the tool accidentally and result in battery
failure by unexpected battery discharge.
[Fig.11]
CAUTION:
When storing or carrying the tool, set
the Forward/Reverse lever to the center
position (switch lock).
NOTE:
Exercise caution to ensure no objects
come into contact with the tool’s trigger
switch.
If an object comes into contact with
the tool’s trigger switch, even while the
Forward/Reverse lever is in the center
position (locked), a small amount of
electric current may continue flowing,
which may cause an excessive dis-
charge from the battery pack and sub-
sequent battery pack failure.
Switch and Forward/Reverse
Lever Operation
[Fig.12]
1. Push the lever for forward or reverse rota-
tion. Check the direction of the lever before
using.
. Depress the trigger switch slightly to start
the tool slowly.
. Speed will increase by pressing the trig-
ger. The tool stops working immediately by
releasing the trigger.
. When done with an application, lock the
switch by centering the lever.
NOTE:
The more the speed control trigger is
pulled, the higher the speed becomes.
CAUTION:
When operating the tool by pulling the
trigger, there may be a momentary lag
before rotation starts. This does not sig-
nal a malfunction.
* This lag occurs as the tool’s circuitry
starts up when the trigger is pulled for
the first time after installing a battery
pack or after the tool has not been
used for at least 1 minute (or at least
minutes when the LED is on). Rotation
will start without any lag during sec-
ond and subsequent operations.
Tightening confirmation lamp
The tightening confirmation lamp can be used
to check whether the torque control function
was activated.
Tool status
Lamp display
Tightening complete
(with torque control
function operation)
Green
(For approx.
seconds)
• Tightening not complete
• Tightening complete
with retightening within 1
second
Red
(For approx.
seconds)
The automatic stop
function has been
activated.
Red
(For approx.
minutes)
CAUTION:
When the tool stops automatically after
the switch is released during impact-
mode tightening and then reengaged
within 1 second, the red lamp will light up
to indicate the risk of excessive torque
application as a result of retightening.
Summary of Contents for EYFPA1C
Page 42: ... 42 MEMO ...
Page 43: ... 43 MEMO ...
