6
7
and the blade block.
3. Remove 3 screws and open the
housing. (See Fig. 7A)
4. Remove the battery from the
chassis. (See Fig. 7B)
[ER2051]
1. Disconnect the power cord from the
AC outlet, and remove the power
cord (K) from the trimmer.
2. Remove the blade from the
trimmer.
3. Remove 3 screws and open the
housing. (See Fig. 8)
4. Remove the circuit block from the
housing. Raise the battery and
insert the screwdriver into (a) to
remove the terminal. Remove the
terminal from the other side in the
same manner.
5. Remove the battery.
Attention
• Do not charge the trimmer at
temperatures below 5 ˚C (41 ˚F) or
above 35 ˚C (95 ˚F), or where it will
be exposed to direct sunlight, or other
heat sources.
• Clean the housing only with a soft
cloth slightly dampened with water or
soapy water. Never use a caustic
cleaner such as benzine or bleach.
• The trimmer may become warm
during operation and normal
recharging. This is normal.
Caution
1. This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision
or instruction concerning use of the
appliance by a person responsible
for their safety. Children should be
supervised to ensure that they do
not play with the appliance.
2. Never tamper with the moving
parts.
3. Do not pick up the trimmer by the
cord. It may become detached,
causing damage or injury.
4. Do not use on animals.
5. Never disassemble the trimmer.
Take it to a qualified service person
when service or repair is required.
6. Do not attempt to use any power
cord other than one specifically
designed for this model. Use only
the included power cord.
7. Do not pull, twist or severely bend
the power cord.
8. Do not wrap the power cord tightly
around the appliance.
9. Keep the Trimmer and power cord
away from water and handle it only
with dry hands.
10. Store the Trimmer and power cord
in a dry area where it will be
protected from damage.
11. Never immerse the Trimmer in
water.
12. The supply cord cannot be
replaced. If the cord is damaged,
the appliance should be scrapped.
This product is intended for household
use only.
Specifications
Power source: See the name plate on
the product.
Motor voltage: 1.2 V
Charging time: 8 hours [ER2031]
1 hour [ER2051]
MEMO
6‑7
2011/08/24 15:39:24
