Panasonic EB-BL600, Service Manual

Page: 67 / 116

7.4 Channel Box Test Commands
The following table outlines the commands available using the channel-box software.
After the handheld unit has been switched on (section 7.3), use the up/down scroll keys on the personal computer
keyboard to select the channel-box command. Use the left/right scroll keys to display the required indication and
press the ENTER key to select the displayed function.
CHANNEL BOX COMMAND INDICATION FUNCTION
TEST MODE
<TERM>
<ReST>
Terminates test mode.
Restarts test mode.
INITIALIZE <INIT>
When RETURN is pressed this will
reset the default channel settings.
CHANGE CH <xxx>
Sets up predefined channel
settings.
POWER LEVEL <xxx>
Allows a specified power level to be
set at the UUT.
TX DATA
<NRL 0>
<NRL 1>
<NRL R>
<ACC R>
Sets TX Modulation to:
Normal burst DATA all 0s
Normal burst DATA all 1s
Normal burst DATA all random
Access burst DATA random
RSSI (DBM) <xxx>
Provides an RSSI reading on the
User specified channel.
SET AGC 1
SET AGC 2
SET AGC 3 <xxx>
<xxx>
<xxx>
Allows changes to AGC levels on
LOW, MIDDLE, HIGH channels.
SP LOOP BACK
<START>
<STOP>
Provides an audio path for use with
the GSM test station.
Sets audio loop-back from TX
audio to RX audio without
processing by the CODEC
PATH CONT
<MOSO>
<MESI>
<MESE>
<MISI>
<MISE>
Sets audio paths:
MIC off speaker off
MIC external speaker internal
MIC external speaker external
MIC internal speaker internal
MIC internal speaker external
VOL. BUZZ <xx>
Sets buzzer volume between
values
0 to 3 (Min to Max)
VOL. SIDE <xx>
Sets 4 side tone volume levels
between
0dB and -18dB
VOL. MIC <xx>
Sets 8 MIC volume levels between
26dB and 40dB
TAM CONT
PLAY ON
PLAY OFF
REC ON
REC OFF Switches on Voice Memo Playback
Switches off Voice Memo Playback
Record Voice Memo on
Record Voice Memo off
VOL. SP1 <xx>
Sets speaker pre-amp volume
levels
VOL. SP2 <xx> Sets speaker volume levels
GET KEY CODE <ENABLE><DISABLE>
Displays the value of a key pressed
on the keypad
MCUK980101C8 Section 7 Issue 1
Service Manual 7 - 7 Revision 0
TEST AND MEASUREMENT