T
ro
uble
s
ho
oting
VQT2J62
86
Messages on the unit’s display
Troubl
eshooti
ng
The following messages or service numbers appear on the
unit’s display when something unusual is detected during
startup and use.
DVD
(“
∑
” stands for a number.)
¾
The remote control and main unit are using different
codes. Change the code on the remote control.
GUIDE
¾
TV Guide data is being downloaded. (
>
22)
FINISH
¾
The software (firmware) update is complete. (
>
84)
HARD ERR
¾
If there is no change after turning the unit on and off,
consult the dealer where the unit was purchased.
NoERAS
¾
You cannot delete items on this disc.
The disc may be damaged. Use a new disc.
NoREAD
¾
The disc is dirty or badly scratched. The unit cannot
record, play, or edit. (
>
3)
¾
This message may appear when the lens cleaner has
finished cleaning.
Press [
<
OPEN/CLOSE] on the main unit to eject the
disc. (
>
16)
NoWRIT
¾
You cannot write to this disc.
The disc may be damaged. Use a new disc.
PLEASE WAIT
¾
Displayed when the unit is started and turned off.
¾
There was a power failure or the AC plug was
disconnected while the unit was on. The unit is carrying
out its recovery process. This process restores the unit to
normal operation. The unit is not broken. Wait until the
message disappears.
PROG FULL
¾
There are already 32 timer programmes. Delete
unnecessary timer programmes. (
>
32)
REMOVE
¾
The USB device is drawing too much power. Remove the
USB device.
START
¾
Update of the software (firmware) is started.
You cannot operate the unit until the update is complete.
(
>
84)
SW-DL
¾
Software (firmware) is downloading.
Download will stop when the power is turned on, or the
timer recording starts. (
>
84)
UNSUPPORT
¾
You have inserted a disc the unit cannot play or record
on. (
>
6)
You tried to operate with a non-compatible USB memory.
UPD
/
(“
∑
” stands for a number.)
¾
The software (firmware) is being updated.
You cannot operate the unit until the update is complete.
(
>
84)
U59
¾
The unit is hot.
The unit switches to standby for safety reasons. Wait for
about 30 minutes until the message disappears.
Select a position with good ventilation when installing the
unit. Do not block the cooling fan on the rear of the unit.
U61
¾
(When a disc is not inserted) Displays when a
malfunction has occurred. This is displayed when the unit
is in the recovery process to return to normal operation.
Once the display clears you can use the unit again.
If it remains displayed, consult the dealer where the unit
was purchased.
1
Press and hold [OK] and the
indicated number button at
the same time for more than
5 seconds. (
>
82)
2
Press and hold [OK] for more
than 5 seconds.
DMRXW480&380GL-VQT2J62_eng.book 86 ページ ２０１０年２月１９日 金曜日 午後５時２分
