71
RQT9046
Ref
erence
General Issues
Operation
Page
Cannot operate the TV or Set
Top Box with the unit’s remote
control.
Change the manufacturer code on the remote control.
•
56
Select TV or Set Top Box mode on the remote control.
•
56
The remote control doesn’t
work.
The remote control code is wrong. Change to the correct code.
•
48
The batteries are depleted. Replace them with new ones.
•
5
Point the remote control at the remote control sensor on the main unit.
•
5
Remove obstacles between the remote control and main unit.
•
−
Remove dust from the transmission window and the unit’s sensor.
•
−
Colored glass may obstruct the signal reception/transmission.
•
−
Don’t place the signal sensor in direct sunlight or in areas that may be
subject to sun exposure.
•
−
It may be necessary to set the code on the remote control again after
changing the batteries.
•
48
It may be necessary to set the manufacturer code again after
changing the batteries.
•
56
The unit is on but cannot be
operated.
Some operations are prohibited by the disc.
•
−
The unit is warm (“U59” appears on the unit’s display). Wait until “U59”
disappears.
•
−
One of the unit’s safety devices may have been activated.
Reset the unit as follows:
Press [POWER
8
] on the main unit to switch to off.
If the unit doesn’t switch to off, reset the unit (
➔
70, “To restore the
unit if it freezes”).
•
−
“U88” is displayed and the disc
cannot be ejected.
The unit is carrying out the recovery process. Do the following to eject the disc:
(1) Press [POWER
8
] on the main unit to switch to off.
If the unit doesn’t switch to off, reset the unit (
➔
70, “To restore the
unit if it freezes”).
(2) While the unit is off, press and hold [
g
] and [CH
1
] on the main unit
at the same time for about 5 seconds. (Ejection may take extra time
depending on discs.) The disc may be defective. Try another disc.
•
−
Cannot eject a disc.
The unit is recording.
•
−
The unit may have a problem. Eject the disc as in (2) above.
•
−
Startup is slow.
Startup takes time in the following situations:
A disc other than a DVD-RAM is inserted.
The clock is not set.
Immediately after a power failure or the AC power supply cord is
connected.
When the unit is connected with an HDMI cable.
•
–
–
–
–
−
A password screen appears
and you are unable to view or
record.
If the unit starts receiving a broadcast with the set rating information,
a password screen appears and you will be unable to view or record.
Enter your password to continue.
•
47
Time is incorrect after using
Auto Clock Setting.
Try again. If the time is still incorrect, set the clock manually.
•
49
Cannot set “24p Output for
DVD-Video”.
Only when the unit is connected to the HDMI terminal of a TV
supporting 24p, you can set “24p Output for DVD-Video”. In some
cases where the unit is connected to a TV via an amplifier/receiver
through the HDMI terminals, you may not be able to set it. In this
case, connect the unit to a TV through the HDMI terminal and
connect it to the amplifier/receiver through any terminal other than
HDMI.
•
55
DMR-EZ28-P̲PC (RQT9046-P).indb 71
DMR-EZ28-P̲PC (RQT9046-P).indb 71
2007/12/07 15:27:23
2007/12/07 15:27:23
