Troubleshooting
VQT4W66
105
You cannot write to this disc.
The disc may be damaged. Use a new disc.
• Displayed when the unit is started and is
switched to standby mode.
• There was a power failure or the AC plug was
disconnected while the unit was on. The unit is
carrying out its recovery process. Wait until the
message disappears.
There are already 32 timer programmes. Delete
unnecessary timer programmes. (
>
32)
The USB device is drawing too much power.
Remove the USB device.
Update of the software (firmware) is started.
You cannot operate the unit until the update is
complete. (
>
94)
Software (firmware) is downloading.
Download will stop when the unit is turned on, or
the timer recording starts. (
>
94)
The media is not supported.
The software (firmware) is being updated.
You cannot operate the unit until the update is
complete. (
>
94)
The unit is hot.
The unit switches to standby for safety reasons.
Wait for about 30 minutes until the message
disappears.
Do not block the cooling fan on the rear of the
unit.
(When a disc is not inserted) A malfunction has
occurred. The unit is trying to restore to the
normal operation. Once the message disappears
you can use the unit again.
If it remains displayed, consult the dealer.
HDMI cannot be output because it is connected to
a model that does not support copyright
protection.
Due to the current disc not having authorised
copyright information, video output is not
performed.
NoWRIT
PLEASE WAIT
PROG FULL
REMOVE
START
SW-DL
UNSUPPORT
UPD
/
(“
∑
” stands for a number.)
U59
U61
U76
U77
DMRBWT835GL_eng.book 105 ページ ２０１３年２月１日 金曜日 午前９時５５分
