Reference
TQBS0024
103
• Displayed when the unit is started and is
switched to standby mode.
• There was a power failure or the AC plug was
disconnected while the unit was on. The unit is
carrying out its recovery process. Wait until the
message disappears.
• There are already 32 timer programmes. Delete
unnecessary timer programmes. (
>
38)
• You are trying to divide a programme when the
maximum possible number of programmes is
already stored on the media.
The USB device is drawing too much power.
Remove the USB device.
Update of the software (firmware) is started.
You cannot operate the unit until the update is
complete. (
>
80)
Software (firmware) is downloading.
Download will stop when the unit is turned on, or
the timer recording starts. (
>
80)
The media is not supported.
The software (firmware) is being updated.
You cannot operate the unit until the update is
complete. (
>
80)
An error has occurred in the antenna’s power
supply. Check to see if the antenna’s cable core
and braided wire shield are in contact with each
other.
The unit is hot.
The unit switches to standby for safety reasons.
Wait for about 30 minutes until the message
disappears.
Install or place this unit with good ventilation.
(When a disc is not inserted) A malfunction has
occurred. The unit is trying to restore to the
normal operation. Once the message disappears
you can use the unit again.
If it remains displayed, consult the dealer.
HDMI cannot be output because it is connected to
a model that does not support copyright
protection.
Due to the current disc not having authorised
copyright information, video output is not
performed.
(When a disc is inserted) There was something
unusual detected with the disc or the unit. The
unit is trying to restore to the normal operation.
Once the message disappears you can use the
unit again.
If it remains displayed, consult the dealer.
The unit fails to operate properly. Press [
Í
/I] on
the main unit to switch the unit to standby mode.
Now press [
Í
/I] on the main unit again to turn the
unit on.
The HOLD function is activated. (
>
83)
PLEASE WAIT
PROG FULL
REMOVE
START
SW-DL
UNSUPPORT
UPD
/
(“
∑
” stands for a number.)
U50
U59
U61
U76
U77
U88
U99
X HOLD
DMR-BST&BCT765&760EG_eng.book 103 ページ 2017年3月2日 木曜日 午後6時35分