Panasonic DMP-BD45EE, Service Manual

Page: 28 / 75

3. Confirm the Tray door spring is attached as following. 10.1.7. BDP/Digital P.C.B. Module
10.1.6. Rear Panel
1. Remove the 4 screws (A) and screw (B).
2. Unlock 2 locking tabs (A) to remove the Rear Panel.
Caution:
Replacing the pair of BD Drive and Digital RC.B. as “BDP/
Digital P.C.B. Module” is recommended.
If the BD Drive unit alone or the Digital P.C.B. alone is
replaced, the replaced BD Drive unit has to be re-adjusted
because of the adjustment data is stored in Digital P.C.B..
For the Drive Adjustment method, see “11. 2. 4. How to
adjust the BDP/Digital P.C.B. Module”.
* To prevent electrostatic damage to the optical pick­
up, please replace without removing FFCs between
BD Drive unit and Digital P.C.B.
CASE 1:
When replacing the pair o f BD Drive and Digital P.C.B.
(Do not rem ove OPU FFC and 18 pin FFC between BD
Drive and Digital P.C.B.)
1. Remove the connector (A).
2. Remove the 3 screws (A) to remove Digital P.C.B..
3. Remove the 4 screws (B) to remove BD Drive.
Screw (B) Connector (A)
BDP/Digital Screw (A)
P.C.B. Module
4. Put Digital P.C.B. on BD Drive and remove BDP/Digital
P.C.B. Module.
28